Abstract:Based on the physical phenomenon that some propagating waves are partially reflected by discontinuities in waveguide structures, this paper proposes a novel discontinuity locating method which is potentially able to detect both the added and embedded discontinuities, such as supports and cracks. In this method, the reflection coefficients of a discontinuity can be obtained experimentally by using a generalized discontinuity approach without the information of the discontinuity position. On the other hand, these reflection coefficients can be derived from a reflection-coefficient prediction model in terms of the discontinuity position. By minimizing the error between the reflection coefficients from measurements and those from the prediction model, in the frequency bands in which the guided waves are sensitive to the discontinuity and can propagate with low decay rate, the discontinuity position parameter in the prediction model can then be identified. Two numerical cases of locating an added discontinuity and an embedded discontinuity on a beam are proposed to introduce the effectiveness of the method. Simulation results show that these two discontinuities can be located accurately with zero error. In practice, the accuracy of discontinuity locating may be influenced by some factors: (1) boundary conditions of the beam, (2) sizes and locations of the discontinuity, and (3) measurement noise. The investigation of these factors in simulation shows that this locating method is insensitive to the boundary conditions of the beam, effective to small size of the discontinuity, and robust to the measurement noise. Finally, three experiments were developed to locate an added discontinuity on a finite beam, a crack in an infinite beam with depth ratio of 1/2, and a crack in an infinite beam with depth ratio of 1/6, respectively. The corresponding locating errors of these three experiments are 0 percent, 0.077 percet and 0.154 percent.

Wavelet-Based Inclusion Detection in Cantilever Beams

INNER CRACK DETECTION METHOD FOR CANTILEVER BEAMS

Damage Detection of Beams Based on Experimental Wavelet Analysis of Flexible Waves

Crack detection of fibre reinforced composite beams based on continuous wavelet transform

Applying Bandgap Defect Modes to Crack Detection in Beams Using Periodic Concentrated Masses

Crack Detection in Beams by Wavelet Analysis

Damage detection of cracked beams based on wavelet transform

Damage detection method for structures based on the relative variation of wavelet total energy

Integrity Assessment for Beam-Like Structures by Continuous Wavelet Transform

Local Variation Detection in Mdof System Using Wavelet Based Transmissibility and Its Application in Cracked Beam

Crack detection in beam structures with a novel Laplace based Wavelet Finite Element method

Crack Detection of Fiber Reinforced Beams Based on Gabor Wavelet Transform

Discontinuity Location on A Timoshenko Beam by Using A Novel Wave Reflection Technique

Damage detection in thick steel beam using lamb waves

On-Line Health Monitoring and Damage Detection of Structures Based on the Wavelet Transform

A mode shape sensitivity-based wavelet feature extraction method for interface debonding detection in concrete-filled steel tubes

Nonlinear Random Vibration Suppression Analysis of Viscoelastic Sandwich Cantilever Beams

Crack Detection in Beams by Wavelet Analysis of Transient Flexural Waves

Direct influence of residual stress on the bending stiffness of cantilever beams

Damage Identification in Thick Steel Beam Based on Guided Ultrasonic Waves

Wave analysis in one dimensional structures with a wavelet finite element model and precise integration method