Abstract:In this paper, the authors present a stress wave-based active sensing method to detect the crack in FRP-reinforced concrete beams. The embedded smart aggregates (SAs), which utilize Lead Zirconate Titanate (PZT) as transducers, are employed in this research to generate and sense the stress wave. Three specimens are involved in the experimental program and each is made of concrete, longitudinal distributed reinforcement, steel stirrups, main bar (FRP bar or steel bar), and four SAs. A pair of SAs installed on the lower part of the main bar and the other pair of SAs mounted on the upper part of main bar are utilized to monitor the crack occurrence and development in the three test specimens. The signals received by the SA sensors are analyzed in both time domain and frequency domain. The wavelet packet energy is used to extract damage features. The applied load–vertical displacement curves of mid-span in the specimen are obtained. Experimental results show the test specimens experience crushing failure when the concrete compression exceeds its compressive strength. Increasing the contact area between FRP bar and concrete can effectively improve the cracking load of the FRP-reinforced concrete beam and reduce the cracking speed and depth of FRP-reinforced concrete beam; on the other hand, increasing the elastic modulus of the main bar can slow down the crack development of concrete on the upper side of the main bar and decrease the displacement of reinforced concrete beam during the loading test process. The research results show that the developed piezoceramic-based active sensing method, though low-cost, can monitor the crack-induced damage and estimate the process of damage degree in real-time, and has potentials to provide an early warning of crack occurrence and development for FRP-reinforced concrete beams.

Crack Detection of Fiber Reinforced Beams Based on Gabor Wavelet Transform

Crack detection of fibre reinforced composite beams based on continuous wavelet transform

Damage detection of cracked beams based on wavelet transform

Crack Detection in Beams by Wavelet Analysis

Damage Detection of Beams Based on Experimental Wavelet Analysis of Flexible Waves

Applying Bandgap Defect Modes to Crack Detection in Beams Using Periodic Concentrated Masses

Crack Detection in Beams by Wavelet Analysis of Transient Flexural Waves

INNER CRACK DETECTION METHOD FOR CANTILEVER BEAMS

Ultrasonic Full Guided Wavefield for Damage Detection in Curved CFRP Parts

Crack Detection of Beam-Structures Based on Transient Waves

Fuzzy logic for crack detection in cantilever-laminated composite beam using frequency response

Damage detection method for structures based on the relative variation of wavelet total energy

A Waveform Clustering Method for Damage Mode Identification for Composite Laminates under Hygrothermal Environment

Damage Detection Method in Complicated Beams with Varying Flexural Stiffness

Crack Detection of FRP-Reinforced Concrete Beam Using Embedded Piezoceramic Smart Aggregates

Crack detection in beam structures with a novel Laplace based Wavelet Finite Element method

Analysis of flexural wave propagation through beams with a breathing crack using wavelet spectral finite element method

Guided wave-based crack detection in U-shaped flexural plate butt welds

Enhanced wavefield imaging method for impact damage detection in composite laminates via laser-generated Lamb waves

Vibration-Based Crack Identification of Generally Supported Beam Structures

Pearson Correlation and Discrete Wavelet Transform for Crack Identification in Steel Beams