Abstract:The thermal conductivity of liquid trans -1,2-dichloroethene (R-1130(E)) was measured at temperatures ranging from 240 K to 340 K and pressures up to 25 MPa using a transient hot-wire instrument. A total of 447 thermal conductivity data points were measured along six isotherms. Each isotherm includes data at nine pressures, which were chosen to be at equal density increments starting at a pressure of 0.1 MPa (or slightly above the saturation pressure of R-1130(E) at temperatures above its normal boiling point) to a maximum pressure of 25 MPa. The combined expanded uncertainty of the presented experimental data is 1.4% at a 95% confidence level. The experimental data were used to evaluate the performance of an extended corresponding states (ECS) model and a residual entropy scaling (RES) model. Both models were applied in a totally predictive mode, and in a mode where the experimental data were used to tune the model parameters. A volume-translated Peng–Robinson equation of state was used to provide thermodynamic properties needed to apply both models. In a totally predictive mode, the ECS model had an average absolute relative deviation (Δ AARD ) of 6.89% relative to the experimental data with the largest deviation being − 8.33%. The RES model in a totally predictive mode showed an Δ AARD of 2.55% with the largest deviation being − 5.81%. When model parameters were fitted to the experimental data, both the ECS and the RES model represented the experimental data to within its uncertainty of 1.4%.

Thermal conductivity of liquid dimethyl ether from (233 to 373) K at pressures up to 30 MPa

Thermal Conductivity of Liquid 1, 2-Dimethoxyethane from 243K to 353K at Pressures up to 30MPa

Isobaric Heat Capacity Measurements for Dimethyl Ether and 1,1-Difluoroethane in the Liquid Phase at Temperatures from 305 K to 365 K and Pressures Up to 5 Mpa

Thermal Conductivity of Gaseous Dimethyl Ether from (263 to 383) K

Thermal conductivity of liquid diethyl ether, diisopropyl ether, and di-n-butyl ether from (233 to 373) K at pressures up to 30 MPa

Thermal Conductivity of Liquid Diethylene Glycol Monomethyl Ether

Measurement of the Thermal Conductivity of Liquid Dimethoxymethane from 240 to 362 K

Thermal Conductivity of Liquid Dimethoxymethane and Dimethoxymethane + Diesel Fuel at Pressures to 30 MPa

Heat Capacity of Saturated and Compressed Liquid Dimethyl Ether at Temperatures from (132 to 345) K and at Pressures to 35 MPa

Thermal Conductivity of Liquid 2-Methoxyethyl Acetate, 2-Ethylhexyl Acetate, and Diethyl Succinate

Thermal Conductivity of Dimethyl Carbonate in Liquid Phase

Vapor Pressure Measurements of Dimethyl Ether from (213 to 393) K

Thermal Conductivity of Liquid trans-1,2-Dichloroethene (R-1130(E)): Measurement and Modeling

Vapor Pressure Measurements of Dimethyl Ether from (233 to 399) K

Measurement of Thermal Conductivity for Systems of Methyl Ethyl Ketoxime with Methyl Ethyl Ketone and N-Hexane Separately

Surface Tension of Dimethyl Ether from (213 to 368) K

Experimental Measurement and Modeling of the Viscosity of Dimethyl Ether

Measurement of the Thermal Conductivities of Toluene, Cyclohexane, and Diethyl Ether at Pressures up to 15.1 MPa and Their Binary Mixtures at Pressures 0.1 and 10.1 MPa from 291 to 351 K

Thermal Diffusivity of 2-Ethoxy-2-methylpropane (ETBE) and 2-Methoxy-2-methylbutane (TAME) at Temperatures from (293 to 523) K and Pressure Up to 10 MPa

Thermodynamic properties of saturated liquid dimethyl ether from adiabatic calorimetry

Compressed Liquid Density Measurements of Dimethyl Ether with a Vibrating Tube Densimeter