Abstract:Schematic illustration of the experimental procedures followed for the hydrothermal growth of ZnO nanorods. In this study, ZnO seed layers with different cycles were formed on glass substrates by the sol–gel technique, and ZnO nanorods were grown on them by the hydrothermal method. Morphology and the structural characterization of the seed films and the ZnO nanorods are carried out by field emission scanning electron microscopy (FE‐SEM) and x‐ray diffraction techniques. In addition, to investigate the effect of seed layer deposition cycles on the optical properties of the ZnO nanorod arrays, UV/visible spectrophotometer and photoluminescence (PL) measurements were performed. The changes in structural and optical parameters such as dislocation density, strain, crystallite size, and optical band gap values on each seed layer deposition cycle were examined. The highest optical band gap and crystallite size were obtained for ZnO nanorods with 4 cycles seed layer as 3.22 eV and 63.6 nm, respectively. Also, in the PL spectrum, the largest ratio of UV‐emission region to weak‐visible emission region was obtained in ZnO nanorods having 4 cycles. In addition, the glucose detection properties of ZnO nanorods having 4 cycles were investigated using the PL measurements and it was found that UV‐emission peak intensity of ZnO nanorods decreased as the glucose concentration increased from 8 to 40 mM. The results show that the number of deposition cycles of the seed layer has a strong influence on the orientation, crystal quality, and optical band gap of the growing ZnO nanorods, as well as significantly affecting their morphological properties. Research Highlights High quality ZnO nanorods were grown on glass substrates by hydrothermal method. The effect of ZnO seed layer cycles on the structural, optical, and morphological characteristics of ZnO nanorods grown on were examined. It was found that the number of cycles of the seed layer is a critical parameter for growing quality and well‐aligned ZnO nanorods.

The Effect of the Texture and the Density of ZnO Seed Layer on the Orientation of ZnO Nanorod Arrays.

Alignment-controlled Hydrothermal Growth of Well-Aligned ZnO Nanorod Arrays

Effect of UV irradiation on the properties of ZnO nanorod arrays prepared by hydrothermal method

Conversion of large-scale oriented ZnO rod array into nanotube array under hydrothermal etching condition via one-step synthesis approach

Density-controlled Hydrothermal Growth of Well-Aligned ZnO Nanorod Arrays

Effect of Seed Layer on Structural Properties of ZnO Nanorod Arrays Grown by Vapor-Phase Transport

Growth of vertically aligned ZnO nanorods using textured ZnO films

Controlling the hydrothermal growth and the properties of ZnO nanorod arrays by pre-treating the seed layer

Preparation of ZnO Nanorod Arrays by Seed-assisted Chemical Bath Deposition Method

Fabrication and Field Emission Properties of ZnO Nanorod Arrays with Different Orientation Degrees

The effect of pre-annealing of sputtered ZnO seed layers on growth of ZnO nanorods through a hydrothermal method

Effects of the Geometries of Micro-Scale Substrates on the Surface Morphologies of ZnO Nanorod-Based Hierarchical Structures

ZnO Nanorods on ZnO Seed Layer Derived by Sol–gel Process

Hydrothermal Grow th of Vertical and Uniform ZnO Nanorod Arrays and Related Influences

Ultrathin Seed-Layer for Tuning Density of ZnO Nanowire Arrays and Their Field Emission Characteristics

Influence of Different Substrates on ZnO Nanorod Arrays Properties

Effects on the ZnO nanorods array of a seeding process made under a static electric field

The effect of seed layer cycles on the structural, optical, and morphological properties of ZnO nanorods

Position and density control in hydrothermal growth of ZnO nanorod arrays through pre-formed micro/nanodots.

The Effect of Cation Doping on the Morphology, Optical and Structural Properties of Highly Oriented Wurtzite ZnO-nanorod Arrays Grown by a Hydrothermal Method.

Effects of Position, Thickness, and Annealing Temperature of Ag Buffer Layer on the Shape of ZnO Nanocrystals Grown by a Simple Hydrothermal Process