Monosodium glutamate wastewater treatment with a full-scale SHARON reactor

TANG Chongjian,唐崇俭,郑平,余燚,陈建伟,陈小光,胡安辉,周尚兴,丁革胜
DOI: https://doi.org/10.3321/j.issn:0253-2468.2008.11.011
2008-01-01
Abstract:The performance of a full-scale SHARON (Single Reactor High Activity Ammonia Removal Over Nitrite) reactor was investigated for treatment of monosodium glutamate wastewater. Results showed that the SHARON process was suitable for treatment of monosodium glutamate wastewater with NH4 +-N concentration of 239.70-341.23 mg·L-1 and COD of 1000-1500 mg·L-1. When the pH of the wastewater was 9.36-10.49, the partial nitrification efficiency (PNE) was higher than 94.56% ± 4.30%. Reactor performance was even stable when the pH values (9.25-9.80) and free ammonia (FA) concentrations (20-70 mg·L-1) in the reactor were higher than the threshold inhibition values. Under these conditions, the effluent pH of the SHARON reactor were around 6.50-7.00 and (NO2 --N)/(NH4 +-N) ratios were maintained at 0.70-1.35 with PNE as high as 96.64% ± 4.73%, which were quite suitable for the subsequent ANAMMOX (Anaerobic Ammonium Oxidation) process. It was also demonstrated that the NO3 --N concentration would increase with low NO2 --N accumulation if the FA concentration was lower than 20 mg·L-1. It is proposed that adjustment of alkalinity by adding lime all at once is suitable for low ammonium-containing wastewater. However, for high ammonium-content wastewater it is recommended that lime should be added several times or in several sections. Otherwise, ammonia-oxidizer may be inhibited by the high pH and FA concentration.
What problem does this paper attempt to address?