Abstract:Based on the model of long-distance and large-capacity UHVAC line with double-end source, two different methods are used to limit overvoltage and the economical evaluation of the two methods are given. One of them is increasing the number of average subsections of transmission line, namely the overvoltage is limited by only adopting metal oxide arrester (MOA) and HV shunt reactor when opening and closing resistors are not used, and the another one is to limit load-rejection opening overvoltage by adding opening and closing resistors to circuit breakers. Simulation results show that the maximum difference of opening overvoltage levels by the two limiting measures is about 0.04 p.u., so the effects of limiting overvoltage by the two methods are basically the same. Through the measure of increasing subsection number of transmission line the load-rejection opening overvoltage under single-phase earth fault can be limited, however the number of required switching stations is more, so the investment cost is high;through adding opening and closing resistors the same purpose of effectively limiting the overvoltage by lesser subsection number of transmission line can be achieved, meanwhile the number of switching stations can be reduced due to decreasing of the number of subsections of transmission line, so hundreds of millions RMB can be saved, and even the highest saved investment cost may be up to 1 billion RMB. Study results also show that the best value of opening resistor is within the range from 600Ωto 700Ω, thus to limit load-rejection overvoltage it is suitable for long-distance and large-capacity transmission lines to add opening and closing resistors.

Optimizing the re-closing time to improve the transmission capacity of power system

The Study on Optimizing Re-Closing Time to Improve the Transmission Capacity

Optimal Reclosing Time of Transmission Lines and Its Application in Real Power System

Corrective Power Network Reconfiguration for Eliminating Transmission Lines Overload

Influence of Single-phase Reclosing Sequence upon Transient Stability Margin of AC/DC Hybrid Transmission System

CALCULATION OF THE OPTIMAL RECLOSING TIME BASED ON EEAC

An Analysis of Optimal Reclosing for Enhancement of Transient Stability.

Optimal reclosure time and its computation

An Adaptive Reclosure Scheme for Parallel Transmission Lines with Shunt Reactors

Adaptive Autoreclosing Scheme for Line-to-Line Nongrounded Faults on Double-Circuit Transmission Lines Based on Phase-to-Phase Reactive Power

Comparative Study on Measures to Limit Load-Rejection Opening Overvoltage of Long-Distance and Large-Capacity UHVAC Transmission Lines

Advanced method for the insertion time of the closing resistor based on the pre-breakdown characteristics

The Actual Operation of Transmission Line and Evaluation of the Reclosing Time of Reclosure

Optimal Power Distribution Method for Wind Farms to Enhance the FRT Capability of the LCC-HVDC System under Commutation Failure

Dominant Frequency Characteristics Analysis of Reclosing Transient Overvoltage in 10 Kv Cable-Overhead Hybrid Line

Optimizing Spinning Reserve Requirement of Power System with Transmission Line Fault

Study of the Concept of Transmission Betweenness Considering the Effect of Reactive Power Flow and Its Application in Identification of Critical Lines in Power Grid

Optimal autoreclosure and its application technique

The Method for Evaluating the Reclosing Time of Reclosure Based on Lightning Parameters

Determination of Optimal Restoration Paths for Power Systems Considering Failure Risk of Restoring Transmission Lines

Research On Reclosing Scheme For Parallel Lines On The Same Tower