Abstract:Displacement piles are driven to support a wide range of structures. However, analysis of the stress and strain fields developed during their installation remains one of the most challenging problems in geotechnical engineering. Advances in design methods, particularly for sand sites, have had to rely on an imperfect analogy between pile and cone penetration test (CPT), rather than modeling pile installation itself. Recent physical model experiments have provided benchmark data sets that describe the stress and deformation patterns developed around displacement piles penetrating sand masses. Following from large-deformation finite-element analyses that captured the stresses measured in the Grenoble 3S-R calibration chamber NE34 sand experiments, this paper presents simulations of the displacements measured in equivalent high-quality experiments conducted at Purdue University with dense, angular #2Q-ROK silica sand. A modified Mohr-Coulomb model with state-dependent parameters was calibrated to match element tests conducted by the authors, and an arbitrary Lagrangian-Eulerian scheme was applied in the simulations. The evolution and distribution of the deformations induced by pile penetration are compared with the experiments. Predictions for the deformation and strain fields applying during and after pile installation are presented, showing broad agreement between the simulations and experiments. The predicted and measured pile capacities are also compared and contrasted. Points of divergence between the simulations and tests are highlighted and their implications for numerical modeling are discussed.

COMPARATIVE STUDY OF DYNAMIC SIMULATION FOR COMPACTING DISPLACEMENT OF JACKED PILE AND IN-SITU TEST

Finite Element Analysis of Compacting Displacements of Single Jacked Pile

Large Deformation Finite-Element Simulation of Displacement-Pile Installation Experiments in Sand

Large-Deformation Finite-Element Simulation of Deformation and Strain Fields Resulting from Closed-End Displacement Pile Installation in Sand

DEM Study of the Stress Fields Around the Closed-Ended Displacement Pile Driven in Sand

STUDY OF COMPACTING SOIL DISPLACEMENTS AROUND JACKED SINGLE PILE BASED ON EXCESS PORE PRESSURE DISSIPATION

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

Numerical Simulation and Factor Analysis of Jacked Pile Compacting Effects

Field Studies on Effect of Jacked Pile on Adjacent Buildings and Roads in Clay

Study On Characteristics Comparison Between Rigid Pile In Composite Foundation With Rigid-Flexible Piles And That In Free State

Squeezing Effects Of Jacked Pile In Layered Soil

Model tests on characteristics of ocean and offshore elevated piles with large lateral deflection

Soil Displacements Around Jacked Group Piles Based on Construction Sequence and Compacting Effects

STUDY ON SINGLE RIGID PILE GROUND IMPROVEMENT MODEL UNDER EMBANKMENT

Numerical Simulation Study on Use of Groove in Controlling Compacting Effects of Jacked Pile

Squeezing Effects of Jacked Pile Considering Static Pile Press Machine's Action

Influence of Prebored Hole Measures on Compacting Effects of Jacked Piles

On Vertical Dynamic Stability and Cross‐section Optimization of Closed‐ended Hollow Pile by Considering Soil Compaction Effects

A Large Deformation Finite Element Investigation of Pile Group Installations with Consideration of Intervening Consolidation

Study on Soil-Compacting Effects Induced by Pipe Jacking Construction

A Model Test on the Behavior of A Static Drill Rooted Nodular Pile under Compression