Abstract:The frequency-interleaved analog-to-digital converter (FI-ADC) can effectively improve the performance of sampling systems by expanding bandwidth and sampling rate as the number of channels increases. However, this improvement may come with drawbacks such as complex hardware requirements and potential mirror errors resulting from an imbalance between in-phase and quadrature-phase signals within the system. This article proposes an alternative FI-ADC architecture, referred to as the sub-band-aliasing (SA) ADC. In the proposed architecture, the analog input signal is divided into multiple sub-bands, and a mixer modulates the input signal to alias adjacent sub-bands. Subsequently, the modulated signal is fed into a low-pass filter (LPF) and an ADC, after which each sub-band is recovered via a recursive process involving spectrum calculation and shifting. Moreover, potential errors that may arise in practical applications are analyzed and compensated. The simulation results indicate that the proposed architecture demonstrates practical utility and can achieve comparable performance to traditional FI-ADCs while featuring a simpler architecture and a lower hardware cost. Furthermore, the effectiveness of the proposed architecture is also demonstrated by hardware experiments, in which an FI-ADC with a total bandwidth of 6 GHz has been implemented using four channels, each channel having a bandwidth of only 1.5 GHz.

A Subdivision Method with High Response Speed and Error Analysis

A Quadrature Demodulation Method with Digital Subdivision and Averaging for a Heterodyne Interferometer

Design Of A Low Power Wide-Band High Resolution Programmable Frequency Divider

An 18-Bit High Performance Audio Sigma-Delta D/A Converter

Design and Realization of the Impedance Signal Decomposer in Eddy Current Instruments Based on DDS Techniques

Design of 1.8 V 8 bit 200 MS/s folding and interpolation ADC

An A/D Converting Technology with High Precision,Low Cost and Multiple Measuring Range

A 1.6-Gsps High-Resolution Waveform Digitizer Based on a Time-Interleaved Technique

Analysis and Simulation of Oversampling Sigma Delta Modulator

A Sub-Sampling 3-Bit 4gs/s Flash ADC in 0.13-&Amp;#x00b5;m CMOS

A Behavioral Simulation Method and an Optimized Design of Sigma-Delta ADC

18-Bit A/D Converter AD7674 and Its Application

Development of High Performance DAC Based on Segment Structure

Research on High-power Subdivision Measurement System based on GEMAC-IP1000B

Electronic Subdividing Method for Linear Encoder of High Speed Position Detection

A Sub-Band-Aliasing Architecture for Frequency-Interleaved Analog-to-Digital Converters

Design of A Parallel Low Power Flash A/D Converter for the Sub-Sampling Ir-Uwb Receiver

A 1-V 23-Μw 88-Db DR Sigma-Delta ADC for High-Accuracy and Low-Power Applications.

2.5-V1 MS/s 12-Bit Successive Approximation Analog-to-Digital Converter

Design of High Precision Linear Encoder based on Direction and Subdivision Algorithm

8 bit 400 MS/s CMOS Folding and Interpolating ADC