Abstract:New time-based readout (TBR) electronics has been developed and evaluated for its performance and application for PET detectors. It consists of a leading edge (LE) timing threshold for timing pickoff that provides a signal timing t1; a charge integration followed by a constant discharge between two specific timings t2 and t3 that are used to directly measure the signal energy. The timing-walk error caused by LE from signals of different amplitudes can be measured with t1 as a function of different signal amplitudes that is proportional to the time difference between t2 and t3. With this pre-calibration, timing-walk error can be accurately corrected. Therefore, both signal timing and energy can be accurately measured with digital timing signals without using CFD and ADC. These timing signals were controlled and in principle can be measured by an FPGA that can apply many signal logic and data correction algorithms. A single channel discrete component TBR circuit has been implemented in PC board, and 8-channel ASIC chips have been developed for feasibility evaluations and PET detector applications. Initial functionality and performance evaluations have been conducted. Signal amplitude measurement accuracy and linearity are very good; the measured timing accuracy from a pulse is the same as a standard CFD and reaches to similar to 100 ps resolution with the test setup. Both suitable energy and coincidence timing resolutions (similar to 17% and similar to 1.0-2.0 ns) were achieved with PMT or Solid-State PM (SSPM) array based PET detectors. Initial studies to acquire flood source crystal identification map has demonstrated the advantages of applying parallel readout with TBR electronics that read out and process signals from each pixel of SSPM array independently. With its relatively simple circuit and low cost, TBR electronics is expected to provide suitable front-end signal readout electronics for compact photon detectors such as SSPM array that require large number of output channels and demand high performance in energy and timing.

An Investigation of Shaper Circuit Optimization for Digitally Pulse Processing in PET

Prototype Design of Readout Electronics for In-Beam TOF-PET of Heavy-Ion Cancer Therapy Device

A Design Implementation of the Central Process Module for an In-Beam PET in HICTD

Energy and Timing Measurement with Time-Based Detector Readout for PET Applications: Principle and Validation with Discrete Circuit Components.

Optimal Design of Waveform Digitisers for Both Energy Resolution and Pulse Shape Discrimination

Sub-Detector Unit Timing Calibration for Brain Pet Based on L1-Norm Constraint

Investigation of Electronic Signal Processing Chains for a Prototype TOF-PET System With 100-ps Coincidence Time Resolution

Front-End Electronics Design Based on Vernier Method for A High Resolution Micropet

Energy And Timing Measurement Of A Pet Detector With Time-Based Readout Electronics

Development of a Prototype PET Scanner with Depth-of-interaction Measurement Using Solid-State Photomultiplier Arrays and Parallel Readout Electronics.

DIET2: A SiPM Readout ASIC for 10 ps TOF-PET application

Enhancing Coincidence Time Resolution of PET Detectors Using Short-Time Fourier Transform and Residual Neural Network

Study on Timing Performance of a Readout Circuit for SiPM

Study of electrode pattern design for a CZT-based PET detector

Prototype design of singles processing unit for the small animal PET

The design of a time-interleaved analog-digital conversion modulator based on FPGA-TDC for PET application

VLSI Implementation of TDC Architectures Used in PET Imaging Systems

Readout Electronics Development Based on an ASIC for PET Detector Using PMT-quadrant-sharing

Nuclear pulse shape discrimination based on DSP techniques

Real-Time FPGA-based Digital Signal Processing and Correction for a Small Animal PET

The high performance parameterization for deep learning in pulse shaping