Abstract:To improve the corrosion resistance, a superhydrophobic silica film on Mg–3.0Nd–0.2Zn–0.4Zr (wt.%, NZ30K) magnesium alloy was successfully prepared by the combination of micro-arc oxidation (MAO) and sol–gel method using tetraethoxysilane (TEOS) and methyltriethoxysilane (MTES) as precursors. The MAO layer with highly porous surface was formed as an intermediate layer to ensure the excellent adhesion of superhydrophobic silica film to the substrate. The parameters of the sol–gel process such as molar ratios of TEOS/C2H5OH and MTES/TEOS had significant effects on the surface morphologies and water-repellent properties of the silica films. A superhydrophobic silica film with static contact angle of 151° was obtained as the molar ratios of TEOS/C2H5OH and MTES/TEOS were 1/30 and 1/2 respectively. It is shown that the superhydrophobic silica film can significantly improve the corrosion resistance of NZ30K magnesium alloy by nearly three orders of magnitude by analysis of the potentiodynamic polarization and electrochemical impedance spectroscopy (EIS) tests in 3.5wt.% NaCl solution. 168h immersion test further demonstrates that the superhydrophobic silica film can effectively provide long-term corrosion protection for NZ30K magnesium alloy. In addition, the superior corrosion protection performance of the superhydrophobic silica film compared with that of the pure silica film without the addition of MTES can be attributed to the good coverage of hydrophobic methyl groups on its surface, which could effectively decrease the direct contact surface to corrosive medium.

Anti-corrosion Nano-Mgo Thin Films on Sintered NdFeB Magnet Surface Prepared by Sol-Gel Method

Corrosion Protection of Nd-Fe-B Sintered Magnets by Aluminum Coating

Nanostructured Magnetite (fe3o4) Thin Films Prepared by Sol–gel Method

Synthesis of Nanocrystalline Magnetite (Fe<sub>3</sub>O<sub>4</sub>) Films by Self-Reduction Sol-Gel Route

Synthesis of Nanocrystalline Magnetite (Fe3O4) Films by Self-Reduction Sol-Gel Route

Study of Nicuzn Ferrite Powders and Films Prepared by Sol-Gel Method

Amorphous Al–Mn Coating on NdFeB Magnets: Electrodeposition from AlCl3–EMIC–MnCl2 Ionic Liquid and Its Corrosion Behavior

Improvement of corrosion resistance and magnetic properties for sintered NdFeB by alumina sol-containing conversion film

Preparation of low-temperature sintered Mn doped Mg-Cu-Zn ferrites by sol-gel self-combustion method

Electro-deposition and Hydrothermal Transition of Alumina Sol Film on Sintered NdFeB Magnets

Preparation and Magnetic Properties of Magnetite Nanoparticles by Sol–gel Method

Preparation of Superhydrophobic Silica Film on Mg–Nd–Zn–Zr Magnesium Alloy with Enhanced Corrosion Resistance by Combining Micro-Arc Oxidation and Sol–gel Method

Magnetic Properties of NiCuZn Ferrite Thin Films Prepared by the Sol-Gel Method

Microstructure and Corrosion Resistance of Sintered Ndfeb Magnet Modified by Intergranular Additions of Mgo and Zno

Preparation of Permanent Magnetic Nanocomposite by Sol-Gel Method and the Magnetic Properties

Preparation and Surface Modification of Fe<sub>3</sub>O<sub>4 &Lt;/sub>nano-Magnetic Powders

Microstructure and Magnetic Properties of NiZn Ferrite Thin Films Prepared by Sol-Gel Method

Synthesis and electrochromic characterization of nanocrystalline NiO thin films prepared by sol-gel method

Fabrication of Lanthanum-Silane Film by Electrochemically Assisted Sol–gel Method for Enhanced Corrosion Resistance of Sintered NdFeB

Preparation of Nanocrystalline Composite Permanent Magnet Mterials and Exchange Coupled Effect

Preparation and Characterization of Amorphous Sio2 Coatings Deposited by Mirco-Arc Oxidation on Sintered Ndfeb Permanent Magnets