Study of Nicuzn Ferrite Powders and Films Prepared by Sol-Gel Method

Gao Liang-Qiu,Yu Guo-Jian,Wang Ying,Wei Fu-Lin
DOI: https://doi.org/10.1088/1674-1056/20/2/027503
2011-01-01
Chinese Physics B
Abstract:This paper reports that a series of NiCuZn ferrite powders and films are prepared by using sol-gel method. The effects of raw material composition and the calcinate temperature on magnetic properties of them are investigated. The NiCuZn ferrite powders are prepared by the self-propagating high-temperature synthesis method and subsequently heated at 700 degrees C similar to 1000 degrees C. The results show that NiCuZn ferrite powders with single spinel phase can be formed after heat-treating at 750 degrees C. Powders obtained from Ni(0.4)Cu(0.2)Zn(0.4)Fe(1.9)O(4) gel have better magnetic properties than those from gels with other composition. After heat-treating at 900 degrees C for 3 h, coercivity H(c) and saturation magnetization M(s) are 9.7 Oe (1 Oe = 80 A/m) and 72.4 emu/g, respectively. Different from the powders, NiCuZn films produced on Si (100) from the Ni(0.4)Cu(0.2)Zn(0.4)Fe(2)O(4) gel formed at room temperature possess high properties. When heat-treating condition is around 600 degrees C for 6 min, samples with low H(c) and high M(s) will be obtained. The minimal H(c) is 16.7 Oe and M(s) is about 300 emu/cm(3). In comparison with the films prepared through long-time heat treating, the films prepared through short heat-treating time exhibits better soft magnetic properties.
What problem does this paper attempt to address?