Abstract:Abstract Residual stress analyses were performed on nitrided, low alloy steels by varying the measuring conditions. The measurements were carried out in the compound layer on ∊-Fe 2–3 N and γ′-Fe 4 N as well as in the diffusion layer on α-Fe. By considering different criteria, tensile residual stresses of up to 300 MPa produced, {111}-interference, for ∊-Fe 2–3 N using CuKα radiation on the specimen's surface. After removing 5 μm from the surface, compressive residual stresses occur in this phase. On employing the CrKα and CuKα radiation, relatively high compressive stresses are obtained of up to above −1000 MPa for γ′-Fe 4 N. For measurements using CrKα radiation, compressive residual stresses result in the diffusion layer for α-Fe, which have a maximum value below the surface. Here, the measurements of the {211}-interference give lower residual stress magnitudes than measurements of the {110}- and {200}-interferences. By verifying the phase superpositions, the linear distributions of line positions or the comparable loading stress analysis using XRD or strain gauges, the results determined at the {211}-interference appear to be realistic. Attention should be paid to the high penetration depth of CrKα radiation. Here, no gradients of the investigated stress states may exist which are too large. The steel possessing a higher content of nitride forming elements such as Al, for example, mainly exhibit the highest compressive residual stresses. In the diffusion layer of 34CrAlNi7-10, maximum compressive residual stresses of −800 MPa result at {211}-interference in α-Fe.

The measurement approach of X-ray residual stress in Fe-Ni alloy with different textures

Method to Analyze and Evaluate the Depth Profile of the Three Dimensional Residual Stresses State with X-ray

Study on Measurement Method of Interior Stress Distributions in Engineering Rolled-Plates

X-Ray Computer Tomography on Residual Stress Measurement

Research on X-Ray Computer Tomography for Measuring Residual Stresses of Beryllium Weldment

Assessing the Residual Stresses in Dissimilar Welded Joint: Depth-Sensing Indentation Testing and Numerical Simulation

Depth-sensing Indentation Measurement and Finite Element Analysis of Residual Stress Field Near Fatigue Crack Tip

A Study of the Back Stress and the Friction Stress Behaviors of Ti-6Al-4V Alloy During Low Cycle Fatigue at Room Temperature

Comparison of residual stress determination using different crystal planes by short-wavelength X-ray diffraction in a friction-stir-welded aluminum alloy plate

Determination of the macroscopic residual stress: Modeling and experimental evaluation of texture and local grain-interaction

Evaluation of Residual Stress Depth Profiling in 7075 Aluminum Alloy Plates

X-ray Residual Stress Analysis of Nitrided Low Alloyed Steels

Recent Progress Of Residual Stress Distribution And Structural Evolution In Materials And Components By Neutron Diffraction Measurement At Rsnd

Measuring texture-component-dependent stress of CuZn39Pb2 by neutron diffraction

Residual Stress Distribution in Laser Alloying Zone with FeCSiB Powder

Experimental validation of residual stress thermomechanical simulation in as-quenched superalloy discs by using diffraction and incremental hole-drilling methods

Systematic investigation of the texture evolution of Cu-Ni alloys with different strains

Residual Stress Analysis of Additive Manufactured A356.2 Aluminum Alloys using X-Ray Diffraction Methods

X-Ray Residual Stress Analysis of Nickel Base Alloys

X-ray Diffraction for the Determination of Residual Stress of Crystalline Material: An Overview

XRD measurement of stacking fault energy of Cr–Ni austenitic steels: influence of temperature and alloying elements