Abstract:Fluidised bed combustion (FBC) has been recognised as a suitable technology for converting a wide variety of fuels into energy. In a fluidised bed, the air is passed through a bed of granular solids resting on a distributor plate. Distributor plate plays an essential role as it determines the gas-solid movement and mixing pattern in a fluidised bed. It is believed that the effect of distributor configurations such as variation of free area ratio and air inclination angle through the distributor will affect the operational pressure drop of the fluidised bed. This paper presents an investigation on pressure drop in fluidised bed without the presence of inert materials using different air distributor designs; conventional perforated plate, multi-nozzles, and two newly proposed slotted distributors (45° and 90° inclined slotted distributors). A 3-dimensional Computational Fluid Dynamics (CFD) model is developed and compared with the experimental results. The flow model is based on the incompressible isothermal RNG k-epsilon turbulent model. In the present study, systematic grid-refinement is conducted to make sure that the simulation results are independent of the computational grid size. The non-dimensional wall distance, is examined as a key factor to verify the grid independence by comparing results obtained at different grid resolutions. The multi-nozzles distributor yields higher distributor pressure drop with the averaged maximum value of 749 Pa followed by perforated, 45° and 90° inclined distributors where the maximum pressure drop recorded to be about one-fourth of the value of the multi-nozzles pressure drop. The maximum pressure drop was associated with the higher kinetic head of the inlet air due to the restricted and minimum number of distributor openings and low free area ratio. The results suggested that low-pressure drop operation in a fluidised bed can be achieved with the increase of open area ratio of the distributor.

Test Obtained Pressure Drop Characteristics of Three Typical Distributor Plate Nozzles in Circulating Fluidized Bed Boilers

Numerical Simulation of flow characteristics in a new-type multistage nozzle of pressure drop

Investigation of pressure drop in a cocurrent downflow three-phase moving bed

Computational and Experimental Study on Pressure Drop in a Fluidised Bed with Different Air Distributor Designs

Study on the Nature of Pressure Signals in a Bubbling Fluidized Bed

Characteristics of a Modified Bell Jar Nozzle Designed for CFB Boilers

Retrofit Design and Numerous Simulation Research on Home-made 200 MW CFB Boiler' S Air Nozzle

Characteristics of a Float Nozzle Designed for CFB Boilers

Dynamic Characteristics of Solids Circulation Establishment in Laboratory and Industrial Circulating Fluidized Beds with Sweeping Bend Return

Experimental investigation of the flow characteristics of low-pressure drop air nozzles working with CFB boilers

Pressure Balance In A Circulating Fluidized Bed

Study on the Atomization Characteristics of High-pressure Nozzle with an In-line Distributor

Research on Pressure Drop in Cir culating Fluidized Beds

Experimental Study on the Pressure Drop Characteristics of Steam-Water Two-Phase Flow at a Low Mass Velocity in a Four-Head Rifled Tube

Experimental and CFD Simulation Studies on Bell-Type Air Nozzles of CFB Boilers

Distribution Characteristics of Downward Water-Cooling Panel in Supercritical Circulating Fluidized Bed Boiler

Effect of Different Nozzle Arrangements on Gas–solid Flow Characteristics of a New Air Distribution System Circulating Fluidized Bed

Effect of Bed Pressure Drop on Performance of A Cfb Boiler

Study of the Pressure Drop of Dense Phase Gas–solid Flow Through Nozzle

Combustion Test by Changing Bed Inventory on Circulating Fluidized Bed Boiler

Test Studying a 75t/h Circulating Fluidized Bed Boiler under Various Modes of Hot State Operation