Abstract:Fluidised bed combustion (FBC) has been recognised as a suitable technology for converting a wide variety of fuels into energy. In a fluidised bed, the air is passed through a bed of granular solids resting on a distributor plate. Distributor plate plays an essential role as it determines the gas-solid movement and mixing pattern in a fluidised bed. It is believed that the effect of distributor configurations such as variation of free area ratio and air inclination angle through the distributor will affect the operational pressure drop of the fluidised bed. This paper presents an investigation on pressure drop in fluidised bed without the presence of inert materials using different air distributor designs; conventional perforated plate, multi-nozzles, and two newly proposed slotted distributors (45° and 90° inclined slotted distributors). A 3-dimensional Computational Fluid Dynamics (CFD) model is developed and compared with the experimental results. The flow model is based on the incompressible isothermal RNG k-epsilon turbulent model. In the present study, systematic grid-refinement is conducted to make sure that the simulation results are independent of the computational grid size. The non-dimensional wall distance, is examined as a key factor to verify the grid independence by comparing results obtained at different grid resolutions. The multi-nozzles distributor yields higher distributor pressure drop with the averaged maximum value of 749 Pa followed by perforated, 45° and 90° inclined distributors where the maximum pressure drop recorded to be about one-fourth of the value of the multi-nozzles pressure drop. The maximum pressure drop was associated with the higher kinetic head of the inlet air due to the restricted and minimum number of distributor openings and low free area ratio. The results suggested that low-pressure drop operation in a fluidised bed can be achieved with the increase of open area ratio of the distributor.

Research on Pressure Drop in Cir culating Fluidized Beds

Investigation of pressure drop in a cocurrent downflow three-phase moving bed

Experimental and numerical investigation of solid behavior in a gas–solid turbulent fluidized bed

Numerical simulation of pressure fluctuation in gas-solids agitated fluidized bed

Experimental study on pressure drop of packed beds with binary sintered ore particle mixtures

Experimental research on solids oscillation circulation behavior in circulating fluidized bed

Experimental Study on Pressure Drop Characteristics of Supercritical Water Fluidized Bed

The Investigation of Pressure Drop in Moving-Beds

Pressure Balance In A Circulating Fluidized Bed

Solids mass flux and mean dynamic solids hold-up in the packed section of the gas-solid-solid circulating fluidized bed

Overall pressure balance and system stability in a liquid–solid circulating fluidized bed

Dynamic Pressure Drop Property of Gas-Liquid Two-Phase Flow around a Horizontal Cylinder

Dynamic Characteristics of Solids Circulation Establishment in Laboratory and Industrial Circulating Fluidized Beds with Sweeping Bend Return

Effect of Bed Thickness on a Pseudo 2D Gas-Solid Fluidized Bed Turbulent Flow Structures and Dynamics

EXPERIMENTAL INVESTIGATION ON PRESSURE DROPS IN FIXED POROUS BEDS PACKED WITH SAND PARTICLES

Flow Characteristics of Gas-solid Two Phase Flowing in the Cross Moving Bed

Pressure Balance Theoretical Analysis of Circulation Loop on CFBB

Single Phase And Two-Phase Flow Pressure Drop In Pebble Beds

Investigation of Pressure Drop for Fluid Flow Through Porous Media: Application to A Pebble-Bed Reactor

Computational and Experimental Study on Pressure Drop in a Fluidised Bed with Different Air Distributor Designs

Modeling of the Minimum Fluidization Velocity and the Incipient Fluidization Pressure Drop in a Conical Fluidized Bed with Negative Pressure