Study on the Atomization Characteristics of High-pressure Nozzle with an In-line Distributor

Zhou Hua,Zhu Chang,Fan Minghao,Yang Huayong
DOI: https://doi.org/10.3969/j.issn.1000-1298.2006.01.017
2006-01-01
Abstract:A type of direct jet nozzle was modified to a nozzle, which was preceded by a swirl chamber with a cross-milled, in-line distributor. The spray status of modified nozzle can be explained by the instability theory. The atomizing parameters of a series of rotational flow nozzles for single-fluid water mist fire suppression were measured with three-dimensional phase Doppler particle anemometer (3D-PDPA). This paper presents the influence of diameters and spray pressure on the atomization of the tested nozzles. The experimental results show that spray cone angle, Sauter mean diameter (SMD) of water mist and axial velocity in the section of 1 m distance from the nozzle change a little, when the spray pressure is higher than 2 MPa. The best spray pressure for the measured nozzles is at 7-8 MPa. The related water mist's SMD is smaller than 100 μm, which belongs to the acceptable range of super water mist.
What problem does this paper attempt to address?