Abstract:The design and fabrication of a resonant pressure sensor based on balanced-mass double-ended tuning fork resonator with twinborn diaphragms are described. It is shown that the thermal stress and the out-of-plane displacement of the vibrating beams of the resonator could be significantly reduced by adopting some appended structures. The simulation results of the frequency versus pressure relationship of the sensor also match the theoretical analysis over the full scale very well. The sensor is fabricated by dry/wet etching and silicon bonding technology with 4’ <100> silicon structure layer and 7740 glass cap. System in packaging is performed with cuboid glass tube to isolate thermal stress. The vacuum packaged sensor is electrostatically excited to vibration, which yields a high $Q$ -factor of 22 795. To compensate and calibrate the sensor under temperature influence, the polynomial algorithm is used. Under self-excited oscillation via an automatic gain control circuit, the sensor is characterized of an experimental maximum error of 0.021%FS over the range 20–185 kPa. Measurements also show a pressure sensitivity larger than 20 Hz/kPa and a zero-load resonant frequency of about 34 kHz. As such, the resonant pressure sensor can be applied in high accuracy pressure measurements. [2015-0294]

Design, Fabrication and Testing of GaAs/AlAs/InGaAs Resonant Tunneling Vector Hydrophones

Design And Measurement Of A Si-Based Vector Hydrophone Based On Piezoresistive Effects

A Novel MEMS Based Piezoresistive Vector Hydrophone for Low Frequency Detection

HBAR sensor based on ALN thin films acoustic bulk wave resonator

Design, Fabrication, and Preliminary Characterization of a Novel MEMS Bionic Vector Hydrophone

High speed surface acoustic wave and laterally excited bulk wave resonator based on single-crystal non-polar AlN film

Fabrication and Characterization of A Microaccelerometer Based on Resonant-Tunneling Diodes

The Material Structure Research of the GaAs-based Resonant Tunneling Diode

Design and Implementation of a Four-Unit Array Piezoelectric Bionic MEMS Vector Hydrophone

Modeling and Characterization of a Micromachined Artificial Hair Cell Vector Hydrophone

Design and implementation of beaded cilia MEMS vector hydrophone

Design and Fabrication of Hollow Mushroom-Like Cilia MEMS Vector Hydrophone

A MEMS-Based Co-Oscillating Electrochemical Vector Hydrophone

Design and fabrication of a novel all-quartz resonant pressure sensor with continuously variable section of DETF

A Novel Resonant Tunneling Diode Based on AlGaAsP/GaAs and Its Circuit Level Design

Design and fabrication of a novel silicon probe for micromachined surface profilers

In-Situ Observing Ciliary Biomimetic Three-Dimensional Vector Hydrophone

Design and Characterization of an Aluminum Nitride-Based MEMS Hydrophone With Biologically Honeycomb Architecture

Design and implementation of hollow cilium cylinder MEMS vector hydrophone

High Accuracy Resonant Pressure Sensor With Balanced-Mass DETF Resonator and Twinborn Diaphragms

Design and implementation of Crossed-circle MEMS ciliary vector hydrophone