Abstract:Due to the rapid adoption of Electric Vehicles (EVs) worldwide, On-Board/Off-Board Battery Chargers are facing numerous. One challenge is charging time since petrol and diesel vehicles are charged 10 times faster than electric vehicles. A second challenge is power density especially for the on-board chargers where minimal space for installation is allocated inside the vehicles. Another challenge is the wide battery voltage range which makes it difficult to optimize the converter over the entire battery voltage range and efficiency drops when either the battery voltage is too high or too lo.. Finally, the bi-directional operation is a challenge to allow the EV to support the grid in peak periods or even standalone loads. In this paper, a 6.6 kW two-stage structure is proposed utilizing a variable dc-link voltage operation. One of the most promising challenges in high-power applications is implementing the magnetics component into Printed Circuit Boards (PCBs). PCB winding transformers are widely in use in low power applications. Compared with conventional Iitz-wire transformers, the manufacturing process is greatly simplified and the parasitic is easier to control. However, due to the limitation of high winding loss and high multi-layer PCB cost in high power applications, the transformer design with PCB winding becomes a challenge. Emerging wide-bandgap devices provide the opportunity to adopt PCB transformers into high power applications. In addition, the low inductance requirement brought by high frequency also makes possible the realization of magnetic integration in PCB transformers.

Design of High Power Density DC-DC Converter Based on Embedded Passive Substrate

Design Considerations For Passive Substrate With Ferrite Materials Embedded In Printed Circuit Board (Pcb)

Structural Design of A Five-Level Hybrid Active Npc Converter for High Power Density Motor Drives

Study of a Single-stage Three-phase PFC DC/DC Converter With Series-parallel Connected Transforms

An Integrated Design of Power Converters for Electric Vehicles.

Power Decoupling Three-Port Converter with Integrated Transformer

A High Power Density 48V-12V DCX with 3-D PCB Winding Transformer

High-Frequency High-Density Bidirectional EV Charger

Utilizing Flexible Printed Circuit Board (FPCB) to Realize Passives Integration in LLC Resonant Converter

High Power Density 48–12 V DCX with 3-D PCB Winding Transformer

A novel PCB winding transformer with controllable leakage integration for a 6.6kW 500kHz high efficiency high density bi-directional on-board charger

Design of a High Performance DC/DC Power for Automotive Application

A High Power Density And Efficiency Bi-Directional Dc/Dc Converter For Electric Vehicles

A WBG based three phase 12.5 kW 500 kHz CLLC resonant converter with integrated PCB winding transformer

Design of a 300 Kw Partial Power Processing Based DC-DC Converter for Electric Vehicles Extreme Fast Charging Stations

Soft-Switching Single-Stage Current-Fed Full-Bridge Isolated Converter for High Power Ac/Dc Applications

Modeling and Design of Integrated Inductor and Transformer Considering Superposed Flux Density in On-Board-Charger

Integration of Both EMI Filter and Boost Inductor for 1-Kw PFC Converter

A PFC Converter With Novel Integration of Both the EMI Filter and Boost Inductor

PFC converter with novel integration of both EMI filter and Boost inductors

High-Density Planar Integrated Magnetics with Two-Sided Merged Inductor Windings and Integrated Cores for Resonant DC/DC Converter