Abstract:The present study examines the influence of polyolester lubricant oil (POEA-68 and POEA-170) with R-134a on the nucleate pool boiling performance for a horizontal smooth tube. The heat flux ranges from 10 kW/m2 to 90 kW/m2 and the lubricant mass fraction varied from 1% to 10% at a saturation temperature of 10 °C, 0 °C and, -6 °C, respectively. The experimental results show that the heat transfer coefficient (HTC) of the pure refrigerant is increased with an increase in saturation temperature. But the presence of lubricant oil alters the HTC considerably. The addition of 3% POEA-68 lubricant shows the highest 29.3% HTC enhancement relative to pure refrigerant at a supplied heat flux of 70 kW/m2 and at a saturation temperature of 0 °C. Whereas for R-134a/POEA-170 lubricant mixture at 3% of mass fraction, the highest enhancement in HTC was around 26% at a supplied heat flux of 70 kW/m2 and -6 °C saturation temperature. The bubble size is reduced and the bubble density is increased appreciably with the addition of POE oil. It was observed that the HTC of lubricant-refrigerant mixtures differs appreciably with the variation of lubricant oi mass fraction (<math>ω</math>). The HTC first decreases at a very low mass fraction (<math>ω</math> ≤ 1%), followed by an appreciable increase in the range of 1% ≤ <math>ω</math> ≤ 3%, and finally reveals a continuous decline for the higher mass fraction. The dramatic decrease in HTC for lubricant-refrigerant mixture is associated with mass transfer resistance and a significant increase in surface tension.

Kinematic Viscosity and Surface Tension of R134a Refrigerant-Oil Mixtures in Saturated Liquid Phase from 273.15 K to 293. 15 K

Kinematic Viscosity of R410a and R407c Refrigerant-Oil Mixtures in the Saturated Liquid Phase with Lubricant Mass Fraction in the Range of (0 to 0.0001)

Surface Tension of R290/Lubricant Oil Mixtures from 243 to 333 K

Surface Tension and Liquid Viscosity Measurement for Binary Mixtures of R134a with R1234yf and R1234ze(E)

Solubility And Miscibility For The Mixture Of (Ethyl Fluoride Plus Polyol Ester Oil)

Isothermal Vapor-Liquid Equilibrium of Binary Mixture (1，1，1，2-Tetrafluoroethane+DME) at Temperature Range From (253.15 to 273.15) K

Experiments on Liquid Viscosity and Surface Tension of Binary Mixture R161 and R134a

Experimental Investigation on the Surface Tension of R1243zf with POE Lubricants from 283 K to 343 K

Thermophysical Properties of 1,1,1,2-Tetrafluoroethane (CH2FCF3) Refrigerant−Oil Mixtures in the Saturated Liquid Phase with Lubricant Concentration in the Range (0 to 100) Ppm

Experimental Investigation on the Surface Tension of R1234ze(E)/POE Lubricant Mixtures from 278 K to 338 K

SURFACE TENSION OF 3,3,3-TRIFLUOROPROPENE/LUBRICANT MIXTURES FROM 283 K TO 343K

Saturated Vapor Pressure of Refrigerant Mixed with Refrigeration Oil

Viscosity Measurement and Correlation of Saturated Solutions of R-290 with Three Lubricants

Surface Tension and Liquid Viscosity of R32+R1234yf and R32+R1234ze

Liquid Viscosity Measurements for the Binary and Ternary Refrigerant Mixtures of R134a, R1234ze(E), and R1234yf

Experimental Study on Miscibility of R134a/R600a Refrigerant and Mineral Oil Mixture

Measurement and Correlation for the Viscosity of R1234yf/POE85 and R1234ze(E)/POE85 Solutions

Nucleate boiling heat transfer of R-134a and R-134a/POE lubricant mixtures on smooth tube

Viscosity and Density of R600a/mineral Oil

An experimental investigation and correlation of the viscosity refrigerant/oil solutions

PR Equation of State Based Friction Theory Viscosity Model for Liquid Refrigerants