Abstract:In this work, experiment was conducted to examine the thermo-physical properties of an alternative refrigerant to HCFC-22 in the presence of polyol ester (POE). The new alternative refrigerant is a mixture of HFC-32/125/161, whose physical properties are similar to HCFC-22 but has a lower global warming potential (GWP) than that of R407C. POE is used as the tested lubricating oil in the experiment. The saturated vapor pressure data and vapor–liquid equilibrium data of nine different mass fractions of the new refrigerant and polyol ester (POE) in the temperature range of 253–323K were measured by single-phase cycle method. The experiment results showed that there was no stratification, no sediment generation in the liquid phase of the mixture, and the color of liquid phase of the mixture had no change in the equilibrium cell before and after the experiment with the POE concentration greater than 20% and the temperature higher than 258K; with POE concentration lower than 20% and temperature lower than 258K, stratification began to appear. Meanwhile, when POE and the refrigerant were miscible, the saturated pressure data of the mixture (HFC-32/125/161+POE) revealed that POE had a very small impact on saturated vapor pressure of the mixture (almost negligible) when POE was less than 10% of the mixture; POE has an obvious effect on the saturated vapor pressure of the mixture when there is more than 10% POE in the mixture, especially when the temperature is higher than 283.15K. Experimental data were correlated by Flory–Huggins model, Heil model, NRTL model and Wilson model. The results showed that to the average and maximum pressure deviation, the results were better with considering the effects of temperature on the energy parameters. Among the above models, the NRTL activity coefficient model was the best, the Heil and Wilson models followed and the Flory–Huggins model had the largest deviation from the experimental data.

Measurement and Correlation for the Viscosity of R1234yf/POE85 and R1234ze(E)/POE85 Solutions

Comparison of Flow Boiling Pressure Drop and Heat Transfer of R134a with Low GWP Alternative R1234ze(E) in a Dimpled Flat Duct

Measurements of the isobaric heat capacity of R1234yf in liquid phase at temperatures from 305 K to 355 K and pressures up to 5 MPa

Isothermal Vapor–Liquid Equilibria of the Absorption Working Pairs (r1234yf + NMP, R1234yf + DMETrEG) at Temperatures from 293.15 K to 353.15 K

Solubility And Miscibility For The Mixture Of (Ethyl Fluoride Plus Polyol Ester Oil)

Experimental Data and Description of the Phase Equilibrium in the Binary System of Ethyl Fluoride and Polyol Ester Oil (planetelf ACD 32)

Experimental Study on the Influence of Flame Retardants under High-Temperature Conditions on the Flammability of R1234ze(E) and R290

Vapor-liquid Equilibrium Measurement and Heating Performance Modeling on Eco-Friendly Zeotropic Blends of CO2/R1234ze(Z) and CO2/R1336mzz(E)

Isothermal Vapor–Liquid Equilibrium of the Ternary Mixture of 1,1,1,2-Tetrafluoroethane + 2,3,3,3-Tetrafluoroprop-1-ene + Dimethyl Ether at Temperatures from 253.15 K to 323.15 K

Investigation on the Vapor–Liquid Equilibrium for the Ternary Mixture HFC-32 + HFC-125 + HFC-161 at Temperatures from 265.15 K to 303.15 K

Vapor–Liquid Equilibrium for the Binary Systems 1,1,2,3,3,3-Hexafluoro-1-propene (R1216) + 2,3,3,3-Tetrafluoroprop-1-ene (r1234yf) and 1,1,2,3,3,3-Hexafluoro-1-propene (R1216) + Trans-1,3,3,3-tetrafluoropropene (R1234ze(e))

Experimental Investigation of Vapor–Liquid Equilibrium for 2,3,3,3-Tetrafluoropropene (Hfo-1234Yf) + Trans-1,3,3,3-tetrafluoropropene (Hfo-1234Ze(e)) at Temperatures from 284 to 334 K

Isothermal Vapor-Liquid Equilibrium Of (Pentafluoroethane Plus Fluoroethane) At Temperatures Between (265.15 And 303.15) K Obtained With A Recirculating Still

Vapor-liquid Equilibrium Measurements and Models for the Ternary Mixtures of R1234yf + R32 + R125 and R1234yf + R32 + CO2

Measurements of the Isobaric Heat Capacity of Pressurized Liquid Trans-1,3,3,3-tetrafluoropropene [r1234ze(e)] by Scanning Calorimetry

Experimental studies on a mixture of HFC-32/125/161 as an alternative refrigerant to HCFC-22 in the presence of polyol ester

Vapor-liquid Equilibrium Measurements for the Binary Mixtures of Pentafluoroethane (R125) with 2,3,3,3-Tetrafluoroprop-1-ene (r1234yf) and 3,3,3-Trifluoropropene (R1243zf)

Effect of viscosity grade (POE) on the smooth-tube pool boiling performance with R-1234ze(E) refrigerant

Mutual Diffusivities of Difluoromethane and 2,3,3,3-Tetrafluoropropylene Dissolved in Polyalkylene Glycol Lubricant

Experimental Investigation on the Surface Tension of R1234ze(E)/POE Lubricant Mixtures from 278 K to 338 K

Isothermal Vapor–Liquid Equilibria of the Absorption Working Pairs (R1234ze(E) + NMP and R1234ze(E) + DMETrEG) at Temperatures from 293.15 to 353.15 K