Abstract:Circular hollow section (CHS) steel members have been widely used in large-span reticulated shells. However, both the axial force and bending moment fluctuate significantly in single-layer reticulated shell members during earthquake events. Therefore, to understand the hysteretic performances of CHS members under a complex loading status, in this study, laboratory tests were performed using eight full-scale CHS samples subjected to combined fluctuating axial force and cyclically increasing lateral drift. Then, the experimental results were compared to those of a numerical analysis. Through full-scale laboratory experiments, ultralow cycle fatigue data for five compressive and three tensile CHS specimens were obtained under different combinations of loading patterns to investigate the different factors influencing the hysteretic behavior of the CHS. These influencing factors include the fluctuating amplitude, frequency, and phase of axial loading cycles relative to unilateral drift. The CHS members under varying compressive axial forces were shown to have a more pronounced global deformation and asymmetric lateral resistance than the members under varying tensile forces. Members under an uncoupled combination of axial load and lateral displacement showed slightly asymmetric lateral force-displacement hysteresis loops. The uncoupled varying axial load and lateral drift slightly influenced the single-cycle energy dissipation capacity of the tensile specimens. However, with a longer fracture life, the total exhausted energy of the tensile specimens increased. In addition, the cyclic void growth model (CVGM) micromechanical fracture prediction theory, which is based on finite element numerical simulations, was also conducted in ABAQUS for comparison to validate the experimental findings. The CVGM theory should not be adopted when the Lode parameters extracted from a "cracked element" are close to 0 in the middle stress triaxiality range with fully developed plasticity.

Experimental study on the hysteretic behavior of T-type SHS joints

Hysteretic behaviour of SHS brace-H-shaped chord T-joints with transverse stiffeners

Behaviour of SHS Brace-H-shaped Chord T-joints under Cyclic In-Plane Bending

Experimental study of the static behavior of tubular N-joints

Hysteretic Behaviour of Tubular Joints under Cyclic Loading

Study on Seismic Behavior of CHS T-joints under Quasi-Static Cyclic In-Plane Bending

Experimental study on behavior of tubular joints under cyclic loading

Study of energy dissipation mechanism of concrete-filled steel tubular T-joints

Hysteretic performance of high-strength steel square hollow section T joints considering fracture behavior

Experimental Research on Hysteretic Property of Unstiffened Space Tubular Joints

Hysteretic Behavior of CHS X-joints under In-Plane Bending Moment

Hysteretic Behavior of a New Assemble Joint under Out-of-plane Bending: Experimental and Numerical Studies

Study on hysteresis behavior of two kinds of reinforced CHS X-joints

Study Of Mechanical Performance Of Concrete-Filled Steel Tubular Joints

Dynamic Behavior of CHS-SHS Tubular T-joints Subjected to Low-Velocity Impact Loading

Hysteretic Performance of CHS Steel Members under Cyclically Fluctuating Axial Loads and Lateral Displacement

Behaviour Of Concrete-Filled Tubular T-Joints Under In-Plane Bending Cyclic Loading

Experimental study on hysteretic behavior of CHS overlap K-joints and Gap KK-joints

Experimental research on hysteretic property of unstiffened tubular x-joints under quasi-static out-of-plane bending

Axial Capacity of CHS T-Joints Reinforced with Welded External Stiffeners Under Load

Effect of Loading Patterns on In-Plane Flexural Hysteretic Performance of CHS X-connections