Abstract:Fault detection of railroad signal cable is of great significance to the safety of railroad system. We propose an improved frequency-domain reflection (FDR) method based on simultaneous sampling of signal and noise for locating high-resistance faults, which is the most common fault in railroad signal cables. First, the return signal of the intact cable core and the inductive signal of the twisted pair are obtained by two-channel simultaneous sampling, and the two signals are Fourier transformed into spatial-domain waveforms. Second, the spatial-domain waveforms of the two signals have ambient noise and noise generated by multiple reflections at the transitions. We calculate the proportionality between the two spatial-domain waveforms by the least square method (LSM), denoted as the transmission factor. Finally, the fault line and its twisted pair are sampled synchronously during subsequent cable fault measurements. The fault line signal is subtracted from the product of the transmission factor and the twisted pair signal. The noise generated by the ambient noise and multiple reflections at the transfer is actively eliminated, highlighting the location of the fault and improving the localization effect of the original FDR method. A hardware system was designed based on this algorithm. The hardware system can transmit a 100-kHz–5-MHz frequency sweep signal to the cable, and the return signal required by the active noise reduction algorithm is collected by two-channel synchronized sampling and intermediate frequency (IF) sampling, and the data processing is subsequently carried out in the host computer. The improved algorithm proposed in this article achieves fault location for high impedance faults in cables below 1000 m, with a maximum resistance of 0.5 M . However, the traditional FDR methods cannot obtain effective positioning results, which verifies the effectiveness and superiority of the proposed method.

A Study on High-Speed Data Acquisition System for Single Ended Traveling Wave Fault Location

FPGA Implementation of High-Speed Data Acquisition System for High-Resolution Millimeter Wave Radar.

High speed video signal acquisition and processing system based on FPGA technique

Equivalent Photoconductive Time-Domain Sampling for Monitoring High-Speed Terahertz Communication Signals

Design and Implementation of a High-Speed Sonar Data Transmission System

FPGA based High Speed Data Acquisition System for High Energy Physics Application

Design of data acquisition system for distributed optical fiber sensor

Traveling wave network location method based on adaptive waveform similarity

Research on Fault Area Location Method of UHV Transmission Line Based on Transient Recording Technology

High frequency signal acquisition and control system based on DSP+FPGA

Eliminating the Dependence of GPS or Communication Latency Estimation in Traveling Wave Based Double-Terminal Fault Location

DMA-based High-Speed Parallel Acquisition System of Digital Signals

Frequency-Domain Localization Method for High-Resistance Faults in Railroad Signal Cables Based on Active Noise Reduction

Enhanced and precise traveling wave fault location accuracy on transmission lines utilizing dual time of arrival

A multi-channel DAQ system based on FPGA for long-distance transmission in nuclear physics experiments

Hardware and Software Design of Programmable Medium and High-Speed Data Acquisition (DAQ) Board of Fiber Optic Signal for Partial Discharge Acquisition

Dynamic Sample Rate Acquisition System Based on Time-to-digital Converter Technology

A Novel Single-Ended Fault Location Scheme and Applications Considering Secondary Circuit Transfer Characteristics

Design of fault location algorithm based on online distributed travelling wave for HV power cable

Single-ended Assembled Fault Location Method and Application Considering Secondary Circuit Transfer Characteristics

Design of 1Gsps high-speed data acquisition card