Hardware and Software Design of Programmable Medium and High-Speed Data Acquisition (DAQ) Board of Fiber Optic Signal for Partial Discharge Acquisition

Ziquan Tong,Jiatong Zhang,Weichao Zhang

DOI: https://doi.org/10.3390/electronics13112176

IF: 2.9

2024-06-03

Electronics

Abstract:The anti-electromagnetic interference capability of partial discharge (PD) acoustic signal conversion and collection circuits severely restrict the sensitivity of PD detection. The data acquisition (DAQ) systems available in the current market are costly and have limited functionality, making it difficult to satisfy the acquisition requirements for PD detection. This paper proposes a medium to high-speed fiber optic signal acquisition board with an adjustably controlled sampling rate and filter cutoff frequency. The circuit achieves a higher signal-to-noise (SNR) ratio by distributing the noise in each part of the signal acquisition chain reasonably. The temperature characteristics of the acquisition module are improved by utilizing the programmable T-type structure for transimpedance amplification of photocurrent. The DAQ card performs data acquisition and processing using STM32H743 internal ADC and caches data in bulk with an SRAM and SD card. A data uploading method based on time reference has been proposed, which enables full, effective information signal upload through a low-cost transmission interface. The research ultimately achieves a stable sampling of three channels at 1 MSps, SNR of 63 dB, and programmable gain amplification of the photocurrent with 0–60 dB. Finally, the system is used for PD acoustic signal acquisition in the frequency range of 20 Hz to 100 kHz.

engineering, electrical & electronic,computer science, information systems,physics, applied

What problem does this paper attempt to address?

This paper focuses on the design of a medium-high speed data acquisition (DAQ) board for partial discharge (PD) detection in fiber optic signals. Existing PD detection methods suffer from inadequate resistance to electromagnetic interference, high costs, and limited functionality. The paper proposes a programmable medium-high speed fiber optic signal DAQ board with adjustable sampling rate and filter cut-off frequency to improve signal-to-noise ratio (SNR). The circuit utilizes a programmable T-structure to improve the temperature characteristics of the photodetector amplifier and uses the internal ADC of STM32H743 for data acquisition, with data being stored in batches on SRAM and SD card. Additionally, a time reference-based data uploading method is proposed to effectively transmit information signals through a low-cost transmission interface. The system achieves stable sampling with three channels at 1 MSps, with an SNR of 63 dB. The programmable gain amplification range of the photodetector current is 0-60 dB, suitable for PD acoustic signal acquisition in the frequency range of 20 Hz to 100 kHz.