Abstract:The non-oxide-reinforced phase AlN-SiC solid solution with high performance was successfully synthesized in the resin-bonded Al-Si-SiC composites under flowing nitrogen at 1300 °C. The AlN-SiC solid solution was synthesized by three paths of liquid-solid, gas-solid and gas-gas reactions through modulation of Al/Si ratio, and controllable microstructure of AlN-SiC solid solution was attained. The phase composition and microstructure of the sintered samples were characterized by XRD and SEM, combined with thermodynamics, the formation mechanism of AlN-SiC solid solution was investigated and the reaction model was established. Al was not detected while Si was detested by XRD. Granular, short columnar and whisker-like AlN-SiC solid solution were generated and their positions varied. As the temperature increases, the partial pressure of oxygen decreases due to the oxidation of Al, Si and SiC on the surface of the sample, inside the sample, the active oxidation takes place, generating Al2O(g), SiO(g) and CO(g). Due to the low oxygen partial pressure, Al is preferentially nitrided to form a thin AlN layer on its surface. The AlN layer is broken as the temperature increases, then liquid Al with carbon from resin begins to flow, leaving the residual shell of AlN in situ. When it flows to the surface of Si, Al-Sialloy is formed locally inside the Si particles under the wetting effect of C, then hexagonal AlN-SiC solid solution is formed inside the Si shell. Part of SiO(g) + CO(g) diffuses into the interior of the AlN residual shell and reacts by aggregation to form a granular AlN-SiC solid solution in the shell wall; others diffuses into the pores of the sample for vapor deposition, and finally forms stacked hexagonal flaky whiskers. The in-situ generated of AlN-SiC solid solution with multiple morphologies in the composite plays a joint toughening effect, which can significantly enhance the comprehensive performance of the composite. In this experiment, the synthesis of AlN-SiC solid solution without sintering aids under normal pressure at a low temperature. It is expected to be applied to the blast furnace and to realize the longevity of blast furnace.

A New Route to Synthesize SiC−AlN Solid Solution Whiskers

Synthesis mechanism of α-Si3N4 whiskers via SiO vapor in reaction bonded Si3N4-SiC composite

Combustion Synthesis of Β-Sialon Whiskers

Synthesis of 2H-Sic Whiskers by Decomposition of Si<sub>3</sub>N<sub>4</sub>

Growth mechanism of Y α-SiAlON whiskers prepared by combustion synthesis

High Yield Silicon Carbide Whiskers from Rice Husk Ash and Graphene: Growth Method and Thermodynamics

Direct observation of the growth process of silicon carbide nanowhiskers by vapor–solid process

Novel Two-Step Process for Synthesising Β-Sic Whiskers from Coal Fly Ash and Water Glass

Formation of AlN whiskers by nitridation of Al/AlN powders

Combustion Synthesis of AlN Whiskers

Preparation of Y-SiAlON rod-like crystals and whiskers by combustion synthesis

Synthesis of alpha-Si3N4 whiskers or equiaxed particles from amorphous Si3N4 powders

Synthesis and characterization of silicon carbide whisker arrays prepared by thermal evaporation method

Thermodynamics and Kinetic Considerations behind the Growth of AlN Whiskers Synthesized by Carbothermal Reduction

Theoretical design and preparation of SiC whiskers catalyzed by Fe-oxides on carbon fibers

Formation mechanism of AlN-SiC solid solution with multiple morphologies in Al-Si-SiC composites under flowing nitrogen at 1300 °C

Growth of aluminium nitride whiskers by sublimation-recrystallization method

Synthesis of Bamboo‐like SiC Whiskers from Waste Silica Fume

Combustion synthesis of AlN-SIC solid solutions

Synthesize Of Aluminum Nitride Whiskers By Carbothermal Reduction

Fabricaion process and growth characteristics of A1N whiskers by sublimation-recrystallization method