Abstract:Dissolution of uranium dioxide by molten zircaloy at high temperatures is an important chemical process affecting the fuel melting during nuclear reactor severe accidents. In this study, the dissolution model, based on the mass transfer model and the dissolution criteria, was developed and incorporated into the Moving Particle Semi-implicit (MPS) method. To verify the dissolution model, the one-dimensional mass transfer between two semi-infinite materials was simulated by the improved MPS code. The sensitivity analyses of the particle size have been conducted since particle size determines the simulation accuracy. Then analyses on dissolution of UO2 by molten zircaloy were performed according to results by the improved MPS code. In this study, two series of experiments on dissolution of UO2 by molten zircaloy conducted by Kim and Olander were simulated respectively. The first series of experiments focuses on mass transfer. The corresponding simulation results of MPS show that the dissolution kinetics of UO2 by molten zircaloy follows the parabolic law, and the penetration depths of chemical elements (U, O, Zr) were limited by time. The second series of experiments concerns on natural convection. The simulation results show that the natural convection of melting process has a significant influence on the dissolution behavior. The results indicate that the dissolution of UO2 by molten zircaloy fits the parabolic law before the concentration of UO2 in the liquid reaches the saturation point. After the concentration of UO2 reaches the saturation point, the dissolution of UO2 by molten zircaloy also obeys the parabolic law. The difference between the two parabolic laws is the dissolution rate. The dissolution rate decreases after the UO2 is saturated in the liquid. For natural convection, the penetration depths of chemical elements (U and O) become deeper, which could accelerate the progress of dissolution.

Comparative Studies on the Dissolution of Ceramic UO2 Pellets in Nitric Acid by Microwave and Conventional Heating

Kinetics Study on the Dissolution of UO 2 Particles by Microwave and Conventional Heating in 4 Mol/l Nitric Acid

Studies on the dissolution kinetics of ceramic uranium dioxide particles in nitric acid by microwave heating

Microwave-assisted dissolution of UO 2 with TBP-HNO 3 complex

Numerical Analysis of the Dissolution of Uranium Dioxide by Molten Zircaloy Using Mps Method

EXPERIMENTAL STUDY ON THE REDUCTION OF IRON ORE AND COAL MIXED PELLETS OF HIGH PHOSPHORUS HEMATITE PRE-TREATED BY MICROWAVE IRRADIATION

Interaction of dry and water-saturated uranium ore with microwave and enhanced extraction of uranium

Enhancement of Uranium Recycling from Tailings Caused by the Microwave Irradiation-Induced Composite Oxidation of the Fe-Mn Binary System.

Preparation of Nano-Kaolinite by Microwave-Assisted Chemical Reaction

Treatment of UO2 Pellets Used for Preparing Fuel Elements of HTR-10 Followed by Supercritical Fluid Extraction

Dissolution kinetics and thermodynamics of uranium from a boltwoodite ore for nuclear fuel cycle application

Effect comparison of microwave heating and muffle heating on treatment of spent SCR catalyst

Disposal of Low Concentration Fume with Solid Waste Modified by Microwave.

Conversion of Ceramic Uo2 Pellets for Htr-10 Fuel Elements into Nitrate with N2o4

Treatment of Blast Furnace Gas Washing Water by Utilization of Coagulation Associated with Microwave

Direct Dissolution of UO2in Carboxyl-Functionalized Ionic Liquids in the Presence or Absence of Fe-containing Ionic Liquids

Research on the drying kinetics for the microwave drying of Y2O3–ZrO2 ceramic powder

U3O8 Acid-Deficient Dissolution Process for Preparation of UO2 Kernels by Sol-Gel Method

Dissolution of Copper and Nickel Mine Tailings in Sulfuric Acid Heated with Microwave

Effect of Microwave-Assisted Heating on Chalcopyrite Leaching of Kinetics, Interface Temperature and Surface Energy

Technology to prepare for U3O8 by calcinations from ammonium diuranate in microwave fields