Abstract:With the development of large span and heavy load modern engineering, concrete-filled steel tubular truss and laced column structures appear constantly. The joints of these structures are mostly circular Concrete-Filled Steel Tubular (CFST) joints. In order to solve the problem of lacking of the research on the mechanical properties of CFST joints, three CFST T-joints and one Circular Hollow Section (CHS) T-joint which was used for comparing were tested under reversed cyclic axial loading, and three CFST T-joints and one CHS T-joint were tested under reversed cyclic in-plane bending loading. The failure modes and the ultimate load carrying capacities of CFST T-joints were concluded and the load-displacement hysteretic curves were also studied. The test results showed that the failure modes of CFST joints and CHS joints with the same geometry were completely different, the ultimate load carrying capacities of CFST joints were much higher than that of CHS joints, which shows that adopting a concrete-filled chord member is the most effective way to improve the strength of the unstiffened tubular joints when subjected to axial loading and in-plane bending, the energy dissipation mechanisms of CFST joints and CHS joints were completely different, but both CFST joints and CHS joints had excellent seismic performances. The energy analysis of CFST joints under differing loading conditions indicated that there was a significant distinction in terms of the energy dissipation mechanism. The axially loaded specimens dissipated energy mainly by plastic deformation of the brace, while the in-plane bending loaded specimens dissipated energy mainly by punching shear of the chord wall at the intersection area. This research can not only provide scientific basis for the design of CFST joints, but also effectively promote the application of CFST truss and laced column, and can promote the improvement and development of the design theory of concrete-filled steel structures.

Experimental Research on Cave-in Ultimate Bearing Capacity of Grouted-Round-steel Tube

Experiment on cave-in ultimate bearing capacity of grouted-square-steel tube

Experimental research on ultimate bearing capacity of grouted-round-steel-tube N-joint

Experimental study of the static behavior of tubular N-joints

Numerical Analysis of Ultimate Strength of Concrete Filled Steel Tubular Arch Bridges

EXPERIMENTAL RESEARCH AND FINITE ELEMENT ANALYSIS ON A WELDED JOINT WITH TUBES INTERSECTED AT TWO DIFFERENT POINTS

Study Of Mechanical Performance Of Concrete-Filled Steel Tubular Joints

Full-scale experimental research on tubular N-joints of square chords with circular braces

Study on In-Plane Behavior of Thin-walled Concrete-filled Steel Tubular Gusset Plate T-joints

Design of concrete filled tubular CHS T-joints under in-plane bending

02.05: Design of concrete-filled steel tubular longitudinal gusset plate connections

Design Of Concrete-Filled Steel Tubular Chs Connections In Tension

Concrete-Filled Steel and Steel Tubular T-Joints under Cyclic In-Plane Bending

Experimental Investigation And Design Of Concrete-Filled Cold-Formed Thin-Walled Steel Tubes Subject To Bending

Experimental Study on the Axial Compressive Strength of Vertical Inner Plate Reinforced Square Hollow Section T-joints

Experimental Investigation of Concrete-Filled Steel Tubular Longitudinal Gusset Plate Connections

Torsional Ultimate Bearing Capacity of Centrifugal Concrete Filled Steel Tube Based on Model of Failure Line

Behaviour of Grouted Stainless Steel Tubular X-joints with CHS Chord under Axial Compression

Experimental and Numerical Study on Ultimate Behaviour of High-Strength Steel Tubular K-joints with External Annular Steel Plates on Chord Circumference

Experimental study and theoretical analysis of ultimate strength of steel tubular K-joints of tall towers

Experimental study of K-type joint of the concrete-filled rectangular steel tube truss