Abstract:Starting with the initial design stage, the ship resistance constitutes one of the most important hydrodynamic aspects. In order to generate and optimize the body lines plan, the ship resistance performance must be considered. In this case, both numerical and experimental methods must be applied to obtain the minimum ship resistance controlled by the speed domain. In the last years, numerical studies based on the Computational Fluid Dynamic (CFD) were implemented in the initial ship design stage in order to analyse the free-surface flow and to predict the ship resistance. The numerical optimization process of the hull forms must be validated by means of the experimental model tests in the specific towing tanks. The constant evolution of the numerical and experimental methodologies can be noted. As a consequence, the accuracy level of the ship resistance prediction is increased; though, difficult numerical problems can occur in case of the unconventional hull forms. Taking into account this aspect, a complex numerical and experimental investigation of the ship resistance problem and free-surface topology was performed in the case of the DTMB surface combatant. A parallel numerical simulation was carried out by using the viscous flow solver ISIS–CFD of the software FINE TM /Marine provided by NUMECA. The solver is based on the finite volume method to build the spatial discretization of the transport equation to resolve the Reynolds-Averaged Navier Stokes (RANS) equation. Closure to turbulence is achieved by making use of the k-ω SST model, while the free-surface is captured through an air-water interface based on the Volume of Fluid (VOF) method. For the validation purpose, the tank conditions are reintroduced in the numerical model to account for any banking effect, especially for the high speed cases. Experimental model tests were performed in accordance with the ITTC standard procedures, while the extrapolation process to the full-scale was obtained by using an in-house code, based on the ITTC 57 method. The experimental results are compared through with some internationally recognized towing tank experiments that have been performed for a similar ship model, showing a good agreement. Also, the numerical results are validated against the experimental data and showed to be within a satisfactory congruence.

An Experimental Study on Pentamaran Resistance Characteristics

Research on the Hydrodynamic Performance of a Pentamaran in Calm Water and Regular Waves

Study on the Resistance of a Large Pure Car Truck Carrier with Bulbous Bow and Transom Stern

Experimental and numerical investigation on the anti-penetration performance of metallic sandwich plates for marine applications

Boat Trial Validation and Resistance Prediction of a 36-Foot Hydrofoil Catamarans Using CFD

Numerical Study of Hydrodynamic Performance of A High Maneuverability Ocean Engineering Ship with Pod Propeller Design

Performance evaluation on the designed v-shaped monohull ship models

Experimental Study on a High-Speed Trimaran-Planing Boat

Numerical and Experimental Investigation on the Free-surface Flow and Total Resistance of the DTMB Surface Combatant

Full-scale CFD simulations for the determination of ship resistance as a rational, alternative method to towing tank experiments

Experimental investigation on resistances from stepped trimaran-planing boats

Investigating Resistance of a Range of Trimaran Designs

Experimental Study on the Influence of a T-foil and Bulbous Bow on the Resistance and Motion in Regular Head Waves of Trimarans

Comparative investigations on hull line optimization based on traditional and fully parametric methods for saving energy

Research On The Resistance And Motions Of A Trimaran In Regular Waves Of Different Wave Amplitudes

Experimental Investigation of Resistance of a 600 Dwt Deep-Vee Vessel

Research on Factors of a Flow Field Affecting Catamaran Resistance Calculation

Impact of the Longitudinal Center of Buoyancy on the Total Resistance of a Passenger Ship

Effects of design and fabrication of segmented ship models on test results of wave-induced loads

Investigation of the effectiveness of a stern foil on a patrol boat by experiment and simulation

The effect of flexible step on the resistance of planing boat and motion mitigation