Abstract:Incorporating steps into a hull reduces the wetted surface, promoting improved hydrodynamic lift and reduced resistance at high speeds, provided that the step is designed appropriately. Traditional hydrodynamics studies rely on scaled model testing in towing tanks, but numerical tools offer a more efficient alternative. This study focused on investigating the hydrodynamic performance of stepped hulls by modifying the parent hull of the Naples Systematic Series (C1). The Computational Fluid Dynamics (CFD) code SIEMENS PLM STAR CCM+ version 2302 was used for simulations, including four different beam Froude numbers (FrB = 1.13, 2.22, 2.56, and 2.96) and a total of 15 hull configurations with single and double steps. By employing a three-dimensional computational analysis of multiphase flow using Dynamic Fluid–Body Interaction (DFBI) and overset mesh, various performance parameters such as resistance coefficient, dimensionless wetted surface, sinkage, and dynamic trim were analyzed. The accuracy of the CFD results was confirmed through comparison with experimental data and grid uncertainty assessment. The study demonstrated that placing a single step near the transom decreased trim and increased resistance and wetted surface. Conversely, positioning a step in the forward section reduced the trim angle at lower step heights but increased trim at higher step heights in single-stepped hulls. The application of these findings contributes to the design optimization of stepped hulls for enhanced performance in high-speed maritime applications.

Experimental investigation on resistances from stepped trimaran-planing boats

Research on the Hydrodynamic Performance of a Pentamaran in Calm Water and Regular Waves

Experimental Study on a High-Speed Trimaran-Planing Boat

Study on the Resistance of a Large Pure Car Truck Carrier with Bulbous Bow and Transom Stern

Numerical Analysis of The Drag Reduction Performance of a Double M-Ship Boat With Stepped Planing-Air Coupling

Numerical Investigation of Single and Double Steps in Planing Hulls

The effect of flexible step on the resistance of planing boat and motion mitigation

Research On The Resistance And Motions Of A Trimaran In Regular Waves Of Different Wave Amplitudes

Investigating Resistance of a Range of Trimaran Designs

Time-domain numerical research of the hydrodynamic characteristics of a trimaran in calm water and regular waves

Experimental Study on the Influence of a T-foil and Bulbous Bow on the Resistance and Motion in Regular Head Waves of Trimarans

Boat Trial Validation and Resistance Prediction of a 36-Foot Hydrofoil Catamarans Using CFD

Investigations of air cushion effect on the slamming load acting on trimaran cross deck during water entry

The Effect of Trimming and Sinkage on the Trimaran Resistance Calculation

Experimental free-drop test investigation into wet-deck slamming loads on a generic trimaran section considering the influence of main hull profile

Experimental study of slamming pressure for a trimaran section with different drop heights and heel angles

Investigation of trimaran slamming under different conditions

Experimental investigation on the air-cushion effect during free fall of a trimaran section using an air escape control method

Experimental drop test investigation into cross deck slamming loads on a trimaran

Inhibition on Porpoising Instability of High-Speed Planing Vessel by Ventilated Cavity

Experimental and numerical investigation on a trimaran airwake, geometry modification