Abstract:Abstract Guide vanes are the most eroded component of the Francis turbine, and flow instabilities around guide vanes influence the flow field at the runner inlet. Guide vane cascade can be considered an alternative method to investigate the flow field, which maintains flow similarity with the prototype turbine. The objective of this paper is to numerically analyze the flow field around the guide vane cascade. A single guide vane cascade numerical model is developed to perform the simulation using commercial software ANSYS 2022. Two turbulence models, shear stress transport k-ω and standard k-ε, perform steady-state simulation at the best efficiency point. The pressure and velocity distribution are obtained at mid-span, and around the pressure and suction sides of the guide vane. Numerical simulation on a scaled prototype full turbine has also been performed to measure the Francis turbine’s torque and efficiency. The modified Bhilangana- III guide vane profile is installed in the B-III hydropower plant in India and taken as a reference Francis turbine. The velocity and pressure distributions obtained around guide vanes of the scaled full turbine are compared with the velocity and pressure distributions of the single guide vane cascade. A difference of 7.25 % in maximum velocity and 9.40 % in maximum pressure at the mid-span of the guide vane is found between the guide vane cascade and scaled full turbine at the best efficiency point. The overall efficiency of the scaled turbine is also measured, and a difference of 0.83 % between the numerical result and scaled hill chart at the best efficiency point was found.

DES SIMULATION ON FRANCIS TURBINE WITH NEW GUIDE VANES

Turbulent Simulation of Francis Turbine with 3D Guide Vanes

Detailed Simulation and Analysis of Pressure Fluctuation in Francis Turbine

Influence of 3D Guide Vanes on the Channel Vortices in the Runner of a Francis Turbine

Fine Simulation of 3-D Unsteady Flows in a Francis Hydro-Turbine on Detached Eddy Simulation

Research on the Turbulent Flow around Guide Vane of Francis Turbine

DDES Simulations of a High-Pressure Turbine Guide Vane

Numerical flow field investigation around guide vane of a high head Francis turbine

Numerical Predictions of Pressure Pulses in a Francis Pump Turbine with Misaligned Guide Vanes

Flow in a Francis Turbine with a Three Dimensional Gate Vane

Vorticity Dynamics Analysis On Flow In Francis Hydraulic Turbine

Experimental and Numerical Analysis of Pressure Pulsation in Francis Turbine

Turbulence simulation and experimental study on new 3D wicket gate of francis turbine

Study on influence of the construction change of the spiral casing and draft tube on the flow loss in low head Francis turbine

Numerical Investigation in the Vaned Distributor under Different Guide Vanes Openings of A Pump Turbine in Pump Mode

Numerical Simulation Of 3d Cavitating Turbulent Flow In Francis Turbine

Optimization design and test verification of guide vanes for a fish-friendly Francis turbine

Simulations of unsteady cavitating turbulent flow in a Francis turbine using the RANS method and the improved mixture model of two-phase flows

EXPERIMENTAL AND CFD SIMULATION VALIDATION PERFORMANCE ANALYSIS OF FRANCIS TURBINE

Numerical simulation of turbulent flow in vane passage based on dynamical mesh technology

Effects of Head and Discharge on Internal Flow Characteristics of a High-Quality Installed 1 GW Francis Turbine