Abstract:For the numerical prediction of waves propagation in composite materials, it is necessary to estimate the mechanical properties in the relevant frequency domain. In the past [Hosten B, Deschamps M, Tittmann BR. Inhomogeneous wave generation and propagation in lossy anisotropic solids. Application to the viscoelastic characterization of composite materials. J Acoust Soc Am 1987;82(5):1763–70; Castaings M, Hosten B, Kundu T. Inversion of ultrasonic, plane-wave transmission data in composite plates to infer viscoelastic material properties. NDT&E Int 2000;33(6):377–92], ultrasonic methods were conceived to measure the viscoelastic anisotropic properties of composites made of polymeric matrix and long fibers (glass, carbon,…). The difficulty to measure many (5, 7 or 9) complex stiffness moduli for orthotropic materials leads to large uncertainties in the measurements of their imaginary parts. This paper presents a simplification of these procedures applied to polymers and reinforced polymers with long fibers. For isotropic materials, the experimental observations show that the imaginary part of any complex stiffness is almost a constant proportion of the real part whatever the modulus is. This indicates that both longitudinal or shear bulk modes have the same amount of attenuation per wavelength. In the more general case of orthotropic materials, many stiffness moduli present the same characteristic, and the benefit is significant since the same percentage may be affected to the imaginary parts of these moduli. Then the measurement procedures can be simplified. Results for isotropic homogeneous polymer and anisotropic polymer/glass fibers composites will be presented to corroborate this experimental observation and simplification. It will be shown that taking into account the attenuation measurement uncertainties, this hypothesis is fully justified.

Evaluation of the Mechanical Spectrum of the Deposited Materials in a Composite System in Torsion Pendulum.

An Approximate Way to Subtract the Mechanical Spectra of Deposited Materials from A Composite Reed-Vibration Method

The mechanical spectra of deposited materials by a composite reed vibration method

The Mechanical Spectra of Glycerol Measured by A Composite Reed Vibration Method

New Composite Reed Vibration Method to Measure the Mechanical Spectra of Liquids

The reliable mechanical spectrum of glycerol by a composite reed vibration method

Comparative Studies of Mechanical Spectra of Glycerol by Single and Double Layer Depositing Composite-Reed Vibration Methods

Semi-analytical Vibration Analysis of FGM Cylindrical Shells Surrounded by Elastic Foundations in a Thermal Environment

MECHANICAL SPECTRA MEASUREMENT OF LIQUIDS USING A COMPOSITE SYSTEM

An Inverse Approach to Determine Complex Modulus Gradient of Field-Aged Asphalt Mixtures

Quick and repeatable shear modulus measurement based on torsional resonance and torsional wave propagation using a piezoelectric torsional transducer

Complex Young's Modulus Measurement by Incident Wave Extracting in a Thin Resonant Bar

Angular Measurement of Acoustic Reflection Coefficients by the Inversion of V(z, T) Data with High Frequency Time-Resolved Acoustic Microscopy

Comments on the ultrasonic estimation of the viscoelastic properties of anisotropic materials

Measurement of Small Strain Shear Modulus of Clean and Natural Sands in Saturated Condition Using Bender Element Test

Mechanical spectra measurement to probe the magnetolattice coupling in cupric oxide

Torsion modulus to hollow glass microsphere additives in unsaturated polyester resin: Dynamic and deformation energy methods

Dynamic monitoring of epoxy reactions and modulus evaluation by a multispectral approach

On the transient vibrations of the advanced composite systems under mechanical loading

Evaluation of Elastic Properties of Anisotropic Cylindrical Tubes Using an Ultrasonic Resonance Scattering Spectroscopy

Method for Determining the Shear Moduli of Composite Materials from Experiments in the Three-Point Transverse Bending