Abstract:The virtual fields method (VFM) is a novel highly efficient non-iterative tool for the identification of the constitutive parameters of materials. The VFM can obtain several constitutive parameters based on the full-field deformation of the specimen measured in a single test. However, the available results demonstrate that the accuracy of the identification result is strongly dependent on the quality of the deformation field, which is generally measured using optical methods. Especially, in the case where a small deformation is applied under elastic loading, the image noise and measurement error will exhibit a significant influence on the identification results. By combining the VFM with moiré interferometry (MI), a MI-based VFM is used to identify the parameters of an orthotropic linear elastic material. A numerical experiment is conducted to examine the feasibility of this method. From the analysis results, we determine that two factors exhibit an influence on the identification accuracy. The reinforcement direction of the orthotropic material is one factor, and the other is the noise in the deformation field. This MI-based VFM is then applied to determine the mechanical parameters of a unidirectional carbon fiber composite material. In the measurement, a three-point bending load is applied to the specimens. A high density grating with a frequency of 1200line/mm grating is replicated on the specimen surface and used for measuring the in-plane deformation fields using a moiré interferometer. The obtained deformation fields are taken as the inputs of the VFM identification process, and the elastic properties of the materials are identified. The obtained results verify the advantage of the proposed method with respect to high accuracy and good noise immunity.

The mechanical spectra of deposited materials by a composite reed vibration method

An Approximate Way to Subtract the Mechanical Spectra of Deposited Materials from A Composite Reed-Vibration Method

The Mechanical Spectra of Glycerol Measured by A Composite Reed Vibration Method

Evaluation of the Mechanical Spectrum of the Deposited Materials in a Composite System in Torsion Pendulum.

New Composite Reed Vibration Method to Measure the Mechanical Spectra of Liquids

The reliable mechanical spectrum of glycerol by a composite reed vibration method

Comparative Studies of Mechanical Spectra of Glycerol by Single and Double Layer Depositing Composite-Reed Vibration Methods

MECHANICAL SPECTRA MEASUREMENT OF LIQUIDS USING A COMPOSITE SYSTEM

A Method for the Quantitative Analysis of a Key Component in Complex Mixtures Using Raman Spectroscopy Based on Peak Decomposition

Raman Spectral Decomposition Based On Multivariate Curve Resolution And Lorentz Function Constraint

Measurement of Small Strain Shear Modulus of Clean and Natural Sands in Saturated Condition Using Bender Element Test

Mechanical spectra measurement to probe the magnetolattice coupling in cupric oxide

Angular Measurement of Acoustic Reflection Coefficients by the Inversion of V(z, T) Data with High Frequency Time-Resolved Acoustic Microscopy

Complex Young's Modulus Measurement by Incident Wave Extracting in a Thin Resonant Bar

Virtual fields method coupled with moiré interferometry: Special considerations and application

Quick and repeatable shear modulus measurement based on torsional resonance and torsional wave propagation using a piezoelectric torsional transducer

Statistical Estimation of Mechanical Parameters of Clarinet Reeds Using Experimental and Numerical Approaches

Simulation and experimental validation of the mechanisms underlying the reduction and enhancement effects of Magnetic-Vibration composite treatment

Dynamic monitoring of epoxy reactions and modulus evaluation by a multispectral approach

A new method for identifying elastic parameters of isotropic materials based on square specimens

Equivalent circuit method based on complete magneto-mechanical coupling magnetostriction parameters for fixed magnetoelectric composites