Abstract:Shanghai Soft-Xray FEL (SXFEL) test facility was designed and built to demonstrate EEHG and HGHG schemes and verify key technologies for the future hard xray FEL facility (SHINE). After three years commissioning 8.8 nm FEL radiation with peak power of 1 MW had been achieved at the end of 2019. The design, fabrication, commissioning and operation of BI system including striplineBPM, Cavity-BPM, screen monitor, bunch length monitor, beam arrival monitor, bunch energy monitor, will be introduced in this paper. Several lessons learned during design stage and beam commissioning stage, such as radiation damage of CCDs and step-motors, bad choice of CBPM working frequency, thermal drift of BAM and so on, will be addressed as well. INTRODUCTION SXFEL Test Facility (SXFEL-TF) was initiated in 2006 and founded in 2014. Its 0.84GeV linac and undulators were installed through 2016 to 2018, it is for testing the cascaded seeding schemes. The main parameters are listed in Table 1. The SXFEL-TF commissioning has completed this year, and the SXFEL user facility (SXFEL-UF) is under construction. The layout of SXFEL-TF and SXFEL-UF are shown in Figure 1. Table 1: SXFEL-TF Parameters Parameter Value Total length 293m Electron energy 0.84 GeV Bunch charge 0.5 nC Repetition rate 10 Hz FEL output 8.8 nm FEL scheme HGHG/EEHG FEL pulse 100-200 fs FEL power >100 MW Figure 1: Layout of SXFEL-TF (top) and SXFEL-UF (bottom). In order to maintain high FEL gain, high performance beam instrumentation system is required for the SXFELTF. Measured beam parameters including bunch charge, beam position (BPM), beam profile, beam arrival time (BAM) and bunch length (BLM). Table 2 lists the beam diagnostic devices included and the required resolution. Table 2: Requirements of SXFEL-TF Diagnostic System

Canadian Light Source Front Ends Development

Beam instrumentation system for shanghai soft x-ray fel test facility*

Beam instrumentation system development and commissioning in ssrf

Study of Generic Front-End Designs for Erl Based Light Sources

A Prototype Compact Accelerator Driven Neutron Source for Canada Supporting Medical and Scientific Applications

Beam Dynamics Design for a Compact Accelerator-Driven Neutron Source

Insertion Device Controls at the Swiss Light Source

Design and Commission of A Superconducting Wiggler X-Ray Beamline for Advanced Materials Investigation at the National Synchrotron Radiation Research Center

Beam physics design of a superconducting linac

Beam Dynamic Design and Study of a Linac with Variable Output Energy for an AB-BNCT Facility

Development of Virtual Accelerator Environment for Beam Diagnostics

Preliminary Design of CSNS-II Linac SRF LLRF

Beamline Analysis for a Laser-Driven Proton Therapy Accelerator Using Superconducting Bends

A 2.45 Ghz Electron Cyclotron Resonance Proton Ion Source and A Dual-Lens Low Energy Beam Transport

The Improvements at CSNS Ion Source

The Design and Initial Testing of the Beam Phase and Energy Measurement System for DTL in the Proton Accelerator of CSNS

Study of neutron shielding collimators for curved beamlines at the European Spallation Source

Transverse Profile Expansion and Homogenization at Target for the Injector Scheme-I Test Stand of China-ADS

An approach for the optical and mechanical design of an X-ray beamline: application to the plane-wave CDI station CATERETÊ/SIRIUS

Design and beam dynamics simulation for the photoinjector of shanghai soft X-ray free electron laser test facility

The Modification at CSNS Ion Source