Abstract:TiO2-diatomite photocatalysts were prepared by sol-gel process with various pre-modified diatomite. In order to obtain diatomite with different surface characteristics, two modification approaches including calcination and phosphoric acid treatment on the micro-structure of diatomite are introduced. The photocatalysts were characterized by XRD, XPS, nitrogen adsorption-desorption isotherms and micromorphology analysis. The results indicate that, compared with pure TiO2, the anatase-to-rutile phase transition temperature of TiO2 loaded on diatomite carrier is significantly increased to nearly 900 degrees C, depending on the different pretreatment method of diatomite. The photocatalytic activities of different samples were evaluated by their degradation rate of methyl orange ( MO) dye under UV and visible-light irradiation. The samples prepared by phosphoric acid pretreatment method exhibit the highest photocatalytic activity. After 90 min of UV irradiation, about 90% of MO is decomposed by the best effective photocatalyst. And after 8 h visible-light irradiation, nearly 60% of MO is decomposed by the same sample. Further mechanism investigation reveals that the H3PO4 pretreatment process can obviously change the surface features of diatomite carrier, cause the formation of Si-O-Ti bond, increase the binding strength between TiO2 and diatomite, restrain crystal growth of loaded TiO2, and thus form thermal-stable meso-porous structure at the granular spaces. It helps to build micro-, meso- and macro-porous hierarchical porous structure in TiO2-diatomite, and improves the charge and mass transfer efficiency during catalyzing process, resulting in the significantly increased photocatalytic activity of TiO2-diatomite pretreated by phosphoric acid. (C) 2014 Elsevier B. V. All rights reserved.

Preparation and characterization of TiO2/4A zeolite composites

Preparation and Properties of TiO2/Bentonite Composite Photocatalytic Materials at Room Temperature

Preparation and Properties of TiO2/illite Composites Synthesized at Different Hydrothermal Ph Values

A high-stability silica-clay composite: synthesis, characterization and combination with TiO2 as a novel photocatalyst for Azo dye.

A Comparative Study of Different Diatomite-Supported Tio2 Composites and Their Photocatalytic Performance for Dye Degradation

Study on the Preparation and Photocatalytic Properties of Au/TiO2 Composite Fibers

Interface Actions Between TiO2 and Porous Diatomite on the Structure and Photocatalytic Activity of TiO2-diatomite

Preparation, Characterization of ZnTiO3/ZnO Composite Materials and Their Photocatalytic Performance

Synthesis of Nano-Tio2/diatomite Composite and Its Photocatalytic Degradation of Gaseous Formaldehyde

Preparation and Photocatalytic Properties of Fe(III)-Grafted TiO<sub>2</sub> Nano-Composite Powders

Calcination effects on sol-gel preparation of porous TiO2/zeolite composites for Acid Red 1 degradation

Preparation of Er3+:YAlO3/Fe-doped TiO2–ZnO and its application in photocatalytic degradation of dyes under solar light irradiation

Effect of Natural Zeolite Supports for Photoactive TiO2 During the Photodegradation Process

Structural and Photocatalytic Properties of TiO2/Zeolite Synthesized using Sol-Gel Method

Sol–gel synthesis of B-TiO2(20%)/HZSM-5 composite photocatalyst for azophloxine degradation

Preparation, characterization and photocatalytic properties of ZnTiO3 powders

Effect of synthesis process steps on the structure and photocatalytic performance of ZnO–TiO 2 composites

Zinc Tungstate Coupled Fluorinated Titanium Dioxide (ZnWO4/F–TiO2) Composites with Enhanced Photocatalytic Activity

Synthesis and characterization of ZnTiO3 with high photocatalytic activity

Relationship between the Surface Composition of Titanium Oxide(IV)/Zeolite Nanocomposites and Their Photocatalytic and Adsorption Properties: X-ray Photoelectron Spectroscopy Data

Effect of Synthesis Process Steps on the Structure and Photocatalytic Performance of ZnO–TiO2 Composites