Sol–gel synthesis of B-TiO2(20%)/HZSM-5 composite photocatalyst for azophloxine degradation

Lili Yang,Yao Zhao,Yuxuan Liu,Wenjie Zhang
DOI: https://doi.org/10.1007/s10971-019-05153-6
2019-10-23
Abstract:Photocatalyst in the supported form is more meaningful in large scale wastewater treatment than using powder material. HZSM-5 zeolite was used to support boron-doped anatase TiO<sub>2</sub> in a sol–gel route in this work. The supported B-TiO<sub>2</sub>(20%)/HZSM-5 composite photocatalyst has strong activity on azophloxine degradation. The crystallite size of anatase TiO<sub>2</sub> slightly increased from 6.1 to 8.4 nm when calcination temperature rose from 350 to 450 °C. The bandgap energies were around 3.3 eV for the composites calcined between 350 and 600 °C. The adsorption–desorption isotherm of the composites was the type IV isotherm for mesoporous material. The porous structure in the supported B-TiO<sub>2</sub> layer was responsible for the variations of both BET surface area and pore volume in the composite. The maximum photocatalytic activity was obtained on the sample calcined at 450 °C. After 30 min of irradiation, 61.8% of the initial azophloxine molecules were degraded on the material. The first order reaction rate constant was 0.06168 min<sup>−1</sup>. Photocatalytic degradation efficiency was enhanced with increasing B-TiO<sub>2</sub> concentration when the B-TiO<sub>2</sub> dosage was below 400 mg/L.
materials science, ceramics
What problem does this paper attempt to address?