Abstract:TiO2-diatomite photocatalysts were prepared by sol-gel process with various pre-modified diatomite. In order to obtain diatomite with different surface characteristics, two modification approaches including calcination and phosphoric acid treatment on the micro-structure of diatomite are introduced. The photocatalysts were characterized by XRD, XPS, nitrogen adsorption-desorption isotherms and micromorphology analysis. The results indicate that, compared with pure TiO2, the anatase-to-rutile phase transition temperature of TiO2 loaded on diatomite carrier is significantly increased to nearly 900 degrees C, depending on the different pretreatment method of diatomite. The photocatalytic activities of different samples were evaluated by their degradation rate of methyl orange ( MO) dye under UV and visible-light irradiation. The samples prepared by phosphoric acid pretreatment method exhibit the highest photocatalytic activity. After 90 min of UV irradiation, about 90% of MO is decomposed by the best effective photocatalyst. And after 8 h visible-light irradiation, nearly 60% of MO is decomposed by the same sample. Further mechanism investigation reveals that the H3PO4 pretreatment process can obviously change the surface features of diatomite carrier, cause the formation of Si-O-Ti bond, increase the binding strength between TiO2 and diatomite, restrain crystal growth of loaded TiO2, and thus form thermal-stable meso-porous structure at the granular spaces. It helps to build micro-, meso- and macro-porous hierarchical porous structure in TiO2-diatomite, and improves the charge and mass transfer efficiency during catalyzing process, resulting in the significantly increased photocatalytic activity of TiO2-diatomite pretreated by phosphoric acid. (C) 2014 Elsevier B. V. All rights reserved.

Preparation and Properties of TiO2/Bentonite Composite Photocatalytic Materials at Room Temperature

Preparation of WO<sub>x</sub>-TiO<sub>2</sub> and the Photocatalytic Activity under Visible Irradiation

Preparation and Photocatalytic Activities of TiO2 Nanotubes with Mixed Crystal Structure

Preparation and Properties of TiO2/illite Composites Synthesized at Different Hydrothermal Ph Values

Preparation and Photocatalytic Activity of TiO<sub>2</sub>/Fe<sub>2</sub>O<sub>3 &Lt;/sub>nanocomposite

TiO2 Intercalated Talc Nanocomposite: Preparation, Characterization, and Its Photocatalytic Performance

Interface Actions Between TiO2 and Porous Diatomite on the Structure and Photocatalytic Activity of TiO2-diatomite

Effect of Calcination Temperature on Crystal Structure and Photocatalytic Prop- Erty of TiO2/Diatomite Nanoparticles

Solvothermal Preparation of Tio2/Montmorillonite and Photocatalytic Activity

EFFECT OF HEAT TREATMENT ON CHARACTERIZATION AND PHOTOCATALYTIC PROPERTIES OF TiO2/BENTONITE NANOCOMPOSITE

Effects of Water Amount and Ph on the Crystal Behavior of a TiO2 Nanocrystalline Derived from a Sol–Gel Process at a Low Temperature

Solvothermal synthesis of stable nanoporous polymeric bases-crystalline TiO2 nanocomposites: visible light active and efficient photocatalysts for water treatment.

Synthesis of Natural Porous Minerals Supported Tio2 Nanoparticles and Their Photocatalytic Performance Towards Rhodamine B Degradation

A Facile Method of Preparing Sandwich Layered TiO2 in Between Montmorillonite Sheets and Its Enhanced UV-light Photocatalytic Activity

Preparation and Analysis of Photocatalytic TiO2 Sol

Preparation and Photocatalysis Performance of BaSO4/TiO2 Composite Particles

Photocatalytic Degradation of a Cationic Azo Dye by TiO2/bentonite Nanocomposite

Preparation of TiO_2 Nanoparticle and Their Photocatalytic Property

Eco-friendly natural clay bentonite supported zirconium titanate (BT–ZrTiO4): synthesis, characterization and photocatalysis and self-cleaning activities

Solvothermal Synthesis of Nanosized Tio2 Particles with Different Crystal Structures and Their Photocatalytic Activities

Preparation of Carbon-Supported Bi/Ti Composites and Its Catalytic Activity under Solar Irradiation