Abstract:Fracture tests are a necessary means to obtain the fracture properties of concrete, which are crucial material parameters for the fracture analysis of concrete structures. This study aims to fill the gap of insufficient test results on the fracture toughness of widely used ordinary C40~C60 concrete. A three-point bending fracture test was conducted on 28 plain concrete and 6 reinforced concrete single-edge notched beam specimens with various depths of prefabricated notches. The results are reported, including the failure pattern, crack initiation load, peak load, and complete load versus crack mouth opening displacement curves. The cracking load showed significant variation due to differences in notch prefabrication and aggregate distribution, while the peak load decreased nonlinearly with an increase in the notch-to-height ratio. The reinforced concrete beams showed a significantly higher peak load than the plain concrete beams, attributed to the restraint of steel reinforcement, but the measured cracking load was comparable. A compliance versus notch-to-height ratio curve was derived for future applications, such as estimating crack length in crack growth rate tests. Finally, fracture toughness was determined based on the double-K fracture model and the boundary effect model. The average fracture toughness value for C50 concrete from this study was 2.0 , slightly smaller than that of lower-strength concrete, indicating the strength and ductility dependency of concrete fracture toughness. The fracture toughness calculated from the two models is consistent, and both methods employ a closed-form solution and are practical to use. The derived fracture toughness was insensitive to the discrete parameters in the boundary effect model. The insights gained from this study significantly contribute to our understanding of the fracture toughness properties of ordinary structural concrete, highlighting its potential to shape future studies and applications in the field.

Experiment Studies on Fracture Energy of Cement Paste and Mortar

Determination of fracture energy of cement paste and mortar using three-point bending test

Experimental determination of fracture parameters for crack propagation in hardening cement paste and mortar

Fracture properties of cement paste and mortar: An experimental investigation

Experimental Study on Fracture Properties of Cementitious Materials

Fracture parametric study on cement-based materials from three-point bending test

Influence of Mineral Admixture on Early-Age Concrete Cracking

A Mesoscopic Approach for the Size Effect on Fracture Energy of Concrete

Experimental study on fracture properties of self-compacting concrete

Microfracture Characterization of Cement Paste at Early Age by Indentation Test

Fracture Toughness And Microstructure Of Concrete At Early-Ages

Fracture Mechanisms of Polymer Cement Mortar: Concrete Interfaces

Experimental Study on Some Factors Affecting Fracture Property of Concrete

Experimental and Numerical Investigation on the Tensile Fracture of Compacted Clay

Experimental study of flexural fatigue behaviour of cement paste at the microscale

Micro Indentation Fracture of Cement Paste Assessed by Energy-Based Method: the Method Improvement and Affecting Factors

Numerical simulation of cracking of early-age concrete three-point beams

Experimental on the Behavior of Beams Strengthened by Polymer-modified Fiber Cement Mortar Under Hydrothermal Conditions

Determination of Concrete Fracture Parameters from a Three-Point Bending Test

Evaluation of Fracture Parameters of Concrete from Bending Test Using Inverse Analysis Approach

Fracture Toughness of Ordinary Plain Concrete Under Three-Point Bending Based on Double-K and Boundary Effect Fracture Models