Abstract:Disturbance of the molten metal flow during ladle filling of the shot-sleeve before the plunger advances in the aluminum alloy high-pressure die casting (HPDC) process causing entrapment defects in the air and oxide film. Slow pouring to control the turbulence of the flow front reduces productivity due to increased cycle time. Furthermore, the risk of cold flake formation increases caused by large temperature drops in accordance with the long cycle time. On the other hand, rapid pouring is desirable for improving productivity, but the risk of air entrapment increases. Therefore, quick and quiet pouring is desirable in the ladle pouring process. In the present study, we focus on variable tilting speed as a method to achieve good ladle pouring to fill the shot-sleeve. The effects of variable ladle tilting speeds and switching times on the wave behavior of molten metal are investigated via visualization experiments and smoothed particle hydrodynamics (SPH) simulations. Furthermore, the plunger advancement process is also examined. From the simulation results, the variable tilting speed from fast to low can suppress the increase in the maximum wave height of molten aluminum alloy. However, the pouring completion time is longer. The wave height is influenced not only by ladle pouring but also by the plunger advancing process. These trends of wave behavior obtained in the simulation are similar to those of the actual phenomenon. Therefore, the present simulation method can accurately estimate the ladle pouring process and plunger advancing process.

Study on the Effects of the Slow Shot Phase on the Flow Patterns of Die-Casting Mold Filling Process

Optimization of Slow Shot Parameters in a Die Casting Process by Numerical Simulation Technique

Numerical Simulation on the Liquid Metal Flow of the Acceleration Phase in the Shot Sleeve of Cold Chamber Die Casting Process

Water Analogue Validation of Numerical Model for Fluid Flow During Slow Shot Phase in Die Casting Process

Numerical simulation and optimization of liquid metal flow in the shot sleeve of cold chamber die casting process

Study and Application of Mold Filling Simulation of Shaped Castings

The Numerical Simulation of Flow Field of the Slow Shot Phase in the Shot Sleeve

Dynamic Model of Mold Filling Process under Low Pressure Casting

Study on Numerical Simulation of Mold Filling and Heat Transfer in Die Casting Process

Numerical Simulation of Die-Casting Mold Filling Process Based on Fractional Step Method

183/1 Research on mould filling process of melt in vertical centrifugal casting

An Improved Mathematical Model to Simulate Mold Filling Process in High Pressure Die Casting Using CLSVOF Method and CSF Model

Study on numerical simulation of mold-filling and solidification processes of shaped casting

Numerical simulation of mold filling of casting with an improved SOLA-VOF method

Numerical Simulation of Fluid Flow and Heat Transfer During Mold Filling for Die Casting

The molding analysis of automobile parts using the die-casting system

Numerical Study on Characteristic Positions and Transition of Flow Patterns in a Slab Continuous Casting Mold

Effects of Different Parameters on Porosity Defects Between the Horizontal and Vertical Shot Sleeve Processes

Study of Mold Filling Simulation on Low Pressure Die Casting for Automobile Wheel Casting

Study on the Influence of Injection Velocity on the Evolution of Hole Defects in Die-Cast Aluminum Alloy

Examination of Variable Tilting Speed on Flow Behavior During Ladle Pouring in Die Casting Using SPH Simulation