Abstract:Since the split-Hopkinson pressure bar (SHPB) test technology was proposed, it has played an important role in the study of dynamic mechanical properties of materials under the impact of dynamic load. It is a major test technology for the study of dynamic mechanical properties of materials. The expansion of the range of materials studied has also posed a challenge to the SHPB test technique, requiring some improvements to the conventional SHPB test apparatus and analysis methods to meet the test conditions and ensure the accuracy of its results. Based on a systematic review of the development of the SHPB test technique and the test principles, the main factors that influence the test's ability to meet the two basic assumptions at this stage are analyzed, and the ways to handle them are summarized. The stress wave dispersion phenomenon caused by the transverse inertia effect of the pressure bar means that the test no longer satisfies the one-dimensional stress wave assumption, while the pulse-shaping technique effectively reduces the wave dispersion phenomenon and also has the effect of achieving constant strain rate loading and promoting the dynamic stress equilibrium of the specimen. Impedance matching between the pressure bar and specimen effectively solves the problem of the test's difficulty because the transmitted signal is weak, and the assumption that the stress/strain is uniformly distributed along the length of the specimen is not satisfied when studying low-wave impedance material with the conventional SHPB test device. The appropriate pressure bar material can be selected according to the value of the wave impedance of the test material. According to the wave impedance values of different materials, the corresponding suggestions for the selection of pressure bar materials are given. Moreover, a new pressure bar material (modified gypsum) for materials with very-low-wave impedance is proposed. Finally, for some materials (foamed concrete, aluminum honeycomb, porous titanium, etc.) that cannot meet the two basic assumptions of the test, the Lagrangian analysis method can be combined with SHPB test technology application. Based on the analysis and calculation of the energy conservation equation, the dynamic constitutive relationship of the materials can be obtained without assuming the constitutive relationship of the experimental materials.

Wave Separation Technique Applied to Impact Compressive Experiment of Concrete

Experimental Study on Stress Wave Propagation in Ultra High Toughness Cementitious Composites

Compressive Impact Tests of Lightweight Concrete with 155-Mm-diameter Spilt Hopkinson Pressure Bar

A New Method for Separation of Waves in Improving the Conventional Shpb Technique

Experimental Study on Split Hopkinson Pressure Bar Pulse-Shaping Techniques for Concrete

Dynamic Behavior of Reactive Powder Concrete in Split Hopkinson Pressure Bar Testing

A new method for the separation of waves. Application to the SHPB technique for an unlimited duration of measurement

Wave dispersion analysis and simulation method for concrete SHPB test in peridynamics

Design, development, and calibration of split Hopkinson pressure bar system for Dynamic material characterization of concrete

On the use of SHPB techniques to determine the dynamic behavior of materials in the range of small strains

The Application Development of Experimental Technique of Hopkinson Pressure Bar

Development of Experimental Methods for Impact Testing by Combining Hopkinson Pressure Bar with Other Techniques

Investigation on the Deformation and Failure Characteristics of Concrete in Dynamic Splitting Tests

THE EFFECT OF STRESS HETEROGENEOUS ON TEST DATA OF CONCRETE USING SHPB

Design and Calibration of a Large-Scale 155-mm Split-Hopkinson Pressure Bar

Experimental and Numerical Studies on the Dynamic Behaviors of Concrete Material Based on the Waveform Features in SHPB Test

Large Dimension Hopkinson Pressure Bar and Its Application

Numerical Simulation of Shpb Experiment and Analysis on Stress Wave

Technique for Combined Dynamic Compression–Shear Testing of PBXs

Review of SHPB Dynamic Load Impact Test Characteristics and Energy Analysis Methods

Numerical study of the influences of pressure confinement on high-speed impact tests of dynamic material properties of concrete