Abstract:The Self-sensing Active Magnetic Bearings (SSAMBs) which feature for the simplification of independent displacement sensors, contribute to both cost reduction and convenience in control and assembly. The key point of this technique is to accurately estimate rotor position signals directly from coil voltages or currents, thus the actuator itself also serves as a virtual displacement sensor. Although several feasible approaches have been proposed to realize the self-sensing process, there still lie limitations in estimation accuracy, robustness and dynamic performance of the system. In fact, due to the nonlinear property of the self-sensing process, few accurate models are available for quantitative analysis of the estimation accuracy, and this restricts further development of this technique. Focusing on the modulation type SSAMBs, an accurate analytical model of the self-sensing in frequency domain is firstly established in this paper. Eddy current effects and filter properties are also considered for better accuracy. Based on this model, we evaluate possible estimation error sources during the self-sensing process, and investigate if the estimation accuracy can be improved fundamentally by selecting main system parameters properly. In this way, the estimation accuracy gets further improved under existing compensation methods, and better system robustness and dynamic performance can be achieved. Finally, the analytical model and associated conclusions are validated through static experiment, 4-Degree of Freedom (DOF) self-sensing rotor levitation experiment and 0-5000 rpm rotating operation experiment on a 4-DOF rigid rotor-radial SSAMBs platform. (C) 2016 Elsevier B.V. All rights reserved.

Self-Sensing Of The Rotor Position And Displacement For An Inset Permanent Magnet Type Bearingless Motor

Rotor Displacement Sensorless Control Strategy for PM Type Bearingless Motor Based on the Parameter Identification

Sensorless Operation Of An Inset Pm Bearingless Motor Implemented By The Combination Approach Of Mras And Hf Signal Injectionac

Permanent Magnet Linear Synchronous Motor Mover Position Estimation at Zero and Low Speed Using Eddy Current Loss Equivalent Resistance

High-Frequency Signal Injection-Based Sensorless Control for Dual-Armature Flux-Switching Permanent Magnet Machine

A Novel Estimation Method of Sensorless Initial Rotor Position for Surface-mounted PMLSM

Rotor Position Estimation Strategy for Self-Sensing Active Magnetic Bearing Considering Eddy Currents

Self-sensing Active Magnetic Bearing Using Real-Time Duty Cycle

An Improved Method to Estimate Initial Rotor Position for Surface-Mounted Permanent Magnet Synchronous Motors

Radial Position Detection Of Five-Phase Bearingless Pm Motor

Research of Sensorless Control for Multiphase Induction Motor Based on High Frequency Injection Signal Technique

A New Signal Injection-based Method for Estimation of Position in Interior Permanent Magnet Synchronous Motors

Displacement sensorless control of a bearingless induction motor based on modified high-frequency signal injection

Rotor position sensorless estimation for permanent magnet synchronous motors

Position Estimation Accuracy Improvement Based on Accurate Modeling of Self-Sensing Active Magnetic Bearings

A Multifrequency Disturbances Identification and Suppression Method for the Self-Sensing AMB Rotor System

Position and radial displacement sensorless control method for bearingless switched reluctance motors

Self-sensing active magnetic bearing using wavelet based position estimation algorithm

Self-Sensing Hysteresis-Type Bearingless Motor

Rotor Incipient Position Detection of Rotor for PMSM Based on High Frequency Current Injection

A Rotor Position Detecting Method Based on Signal Injection for Lci Fed Electrically Excited Synchronous Motors