Abstract:The Self-sensing Active Magnetic Bearings (SSAMBs) which feature for the simplification of independent displacement sensors, contribute to both cost reduction and convenience in control and assembly. The key point of this technique is to accurately estimate rotor position signals directly from coil voltages or currents, thus the actuator itself also serves as a virtual displacement sensor. Although several feasible approaches have been proposed to realize the self-sensing process, there still lie limitations in estimation accuracy, robustness and dynamic performance of the system. In fact, due to the nonlinear property of the self-sensing process, few accurate models are available for quantitative analysis of the estimation accuracy, and this restricts further development of this technique. Focusing on the modulation type SSAMBs, an accurate analytical model of the self-sensing in frequency domain is firstly established in this paper. Eddy current effects and filter properties are also considered for better accuracy. Based on this model, we evaluate possible estimation error sources during the self-sensing process, and investigate if the estimation accuracy can be improved fundamentally by selecting main system parameters properly. In this way, the estimation accuracy gets further improved under existing compensation methods, and better system robustness and dynamic performance can be achieved. Finally, the analytical model and associated conclusions are validated through static experiment, 4-Degree of Freedom (DOF) self-sensing rotor levitation experiment and 0-5000 rpm rotating operation experiment on a 4-DOF rigid rotor-radial SSAMBs platform. (C) 2016 Elsevier B.V. All rights reserved.

Sensorless Operation of an Inset PM Bearingless Motor Implemented by the Combination Approach of MRAS and HF Signal Injection

High-Frequency Signal Injection-Based Sensorless Control for Dual-Armature Flux-Switching Permanent Magnet Machine

Rotor Displacement Sensorless Control Strategy for PM Type Bearingless Motor Based on the Parameter Identification

Analysis of Position Errors in High-Frequency Carrier Signal Injection Based Sensorless Control of PMSM

Sensorless Interior-Pmsm Control with Rotational Inertia Adjustment

A Novel Estimation Method of Sensorless Initial Rotor Position for Surface-mounted PMLSM

Sensorless Operation Of Pmsm By High Frequency Signal Injection Using The Field-Circuit Coupled Solution

Self-Sensing Of The Rotor Position And Displacement For An Inset Permanent Magnet Type Bearingless Motor

COMPARATIVE INVESTIGATION OF SENSORLESS CONTROL WITH TWO HIGH-FREQUENCY SIGNAL INJECTION SCHEMES

A Full-Speed Sensorless Control Algorithm For Interior Permanent Magnet Synchronous Motor Using Sliding-Mode Observer And Hf Signal Injection

Research of Sensorless Control for Multiphase Induction Motor Based on High Frequency Injection Signal Technique

INVESTIGATION OF ROTOR SALIENCY-TRACKING BASED SENSORLESS VECTOR CONTROL DRIVE FOR PMSM

Sensorless control and start-up strategy of permanent magnet synchronous motor

Position Sensorless Control Based on Sliding Mode Observer for Multiphase Bearingless Motor with Single Set of Windings

Sensor Integrated Concept Based Rotor Position Detection of a PM Synchronous Motor

An Improved Rotor Position Estimation Method for PMSM Using Low-Resolution Hall-Effect Sensors

Position Estimation Accuracy Improvement Based on Accurate Modeling of Self-Sensing Active Magnetic Bearings

Rotor Position Estimation Strategy for Self-Sensing Active Magnetic Bearing Considering Eddy Currents

Research on Sensorless Control Method of PMSM Based on an Adaptive Sliding Mode Observer

Sensorless Control of Surfaced-Mounted Permanent Magnet Synchronous Motor in a Wide-Speed Range

Speed Sensorless of PMSM with High-frequency Signal Injection