Abstract:In this paper, the authors present a stress wave-based active sensing method to detect the crack in FRP-reinforced concrete beams. The embedded smart aggregates (SAs), which utilize Lead Zirconate Titanate (PZT) as transducers, are employed in this research to generate and sense the stress wave. Three specimens are involved in the experimental program and each is made of concrete, longitudinal distributed reinforcement, steel stirrups, main bar (FRP bar or steel bar), and four SAs. A pair of SAs installed on the lower part of the main bar and the other pair of SAs mounted on the upper part of main bar are utilized to monitor the crack occurrence and development in the three test specimens. The signals received by the SA sensors are analyzed in both time domain and frequency domain. The wavelet packet energy is used to extract damage features. The applied load–vertical displacement curves of mid-span in the specimen are obtained. Experimental results show the test specimens experience crushing failure when the concrete compression exceeds its compressive strength. Increasing the contact area between FRP bar and concrete can effectively improve the cracking load of the FRP-reinforced concrete beam and reduce the cracking speed and depth of FRP-reinforced concrete beam; on the other hand, increasing the elastic modulus of the main bar can slow down the crack development of concrete on the upper side of the main bar and decrease the displacement of reinforced concrete beam during the loading test process. The research results show that the developed piezoceramic-based active sensing method, though low-cost, can monitor the crack-induced damage and estimate the process of damage degree in real-time, and has potentials to provide an early warning of crack occurrence and development for FRP-reinforced concrete beams.

Crack identification in a steel beam through piezoelectric self-sensing actuators

Applying Bandgap Defect Modes to Crack Detection in Beams Using Periodic Concentrated Masses

Identification of a Moving Mass on a Beam Bridge Using Piezoelectric Sensor Arrays

Crack Detection of FRP-Reinforced Concrete Beam Using Embedded Piezoceramic Smart Aggregates

Integrated Structural Health Assessment Using Piezoelectric Active Sensors

Identification of Static Loading Conditions Using Piezoelectric Sensor Arrays

Electromechanical Impedance Response of a Cracked Functionally Graded Beam with Imperfectly Bonded Piezoelectric Wafers

Application of Emi Technique for Crack Detection in Continuous Beams Adhesively Bonded with Multiple Piezoelectric Patches

An electromechanical impedance approach for quantitative damage detection in Timoshenko beams with piezoelectric patches

Exploration of damage detection of imperfect composite beams using high-frequency piezoelectric signatures

Damage Evaluation in Shear-Critical Reinforced Concrete Beam using Piezoelectric Transducers as Smart Aggregates

Concrete Damage Diagnosis Using Electromechanical Impedance Technique

Surface strain distribution method for delamination detection using piezoelectric actuators and sensors

Electromechanical Impedance Analysis on Piezoelectric Smart Beam with a Crack Based on Spectral Element Method

Damage identification for a beam structure based on a PVDF piezoelectric film combined sensor

Nonlinear piezoelectric impedance modulation induced by a contact-type failure and its application in crack monitoring

Model experiments of damaged structural identification based on electro-mechanical impedance technique

Assessment of Fatigue Damage of Prefabricated Concrete Composite Beams with Piezomagnetic Signal

Quantitative Structural Damage Detection Using High-Frequency Piezoelectric Signatures Via The Reverberation Matrix Method

An electro-mechanical impedance model of a cracked composite beam with adhesively bonded piezoelectric patches

Monitoring interfacial defects in a composite beam using impedance signatures