Abstract:The radial and axial vibration signals of a rotating machine are crucial information to understand the machine operation and to diagnose potential faults. Instead of using three single sensors to measure the horizontal, vertical and axial displacements of rotating shafts, a novel non-projection vision-based system was proposed to realize simultaneous measurement of the radial and axial displacements with high accuracy and good reliability using an tailored artificial constant density sinusoidal fringe pattern (CDSFP), which was pasted around the shaft surface and worked as a tri-axial (i.e. the horizontal, vertical and axial) displacement sensor. The measurement principle and setup of the proposed measurement system were well established. The horizontal displacement could be correctly obtained from the fringe period density changes of the CDSFP image sequence recorded by a high-speed camera. Simultaneously, the vertical displacement could be acquired by tracking the centerline of shaft whilst the axial displacement could be obtained by locating the peaks of the cross-correlation sequence of the fringe intensities. A sub-pixel method was employed to improve the displacement resolution of the developed system. The performance of the proposed system was demonstrated by the comparison of the experiments using eddy current sensors. It showed that the proposed method was an effective and accurate technique for real-time tri-axial vibration monitoring of rotating shaft. Experimental results verified the feasibility, effectiveness and good robustness of the proposed methodology, which demonstrated that the proposed system was capable of achieving accurate tri-axial vibration displacements of rotating shaft compared to the commercial eddy current sensor which could only measure one dimensional displacement at each measurement. Therefore, the vision-based tri-axial vibration monitoring system could be recommended for real engineering applications in condition monitoring of rotating shafts. (C) 2018 Elsevier Ltd. All rights reserved.

Fiber sensor used in detecting radial vibration of high rotating speed shaft

Research on Dynamic Performance Evaluation of Fiber Optic Gyroscope Based on Laser Doppler Measurement Technology

Key technology study on radial vibration detection system of high-speed rotating machinery

Torsional vibration measurements on rotating shaft system using laser doppler vibrometer

Optical Fiber Sensor Applied to Detect the Vibration of Electrical Machines

Application of fiber optic sensor measurement systemto spinning superconducting rotor instrument

A Fiber Optic Sensor Measurement System for A Levitated Sphere-Shaped Superconducting Rotor

Measurements of radiation vibrations of turbomachine blades using an optical-fiber displacement-sensing system

A non-contact fiber Bragg grating vibration sensor.

Optical fiber vibration sensor for bearing fault detection based on Sagnac interferometer

FBG-based non-contact vibration measurement and experimental study

Applying fiber-optic system to control shaft torque

Simple low-frequency optical fiber accelerometer with large rotating machine monitoring applications

Belt conveyor speed detection based on fiber-optic Sagnac interferometer vibration sensor

Transmission and measurement characteristics evaluation of surface acoustic wave sensor on rotating spindle in machine tools

Assessment of Fiber Bragg Grating Sensors for Monitoring Shaft Vibrations of Hydraulic Turbines

Real-time Three-Dimensional Vibration Monitoring of Rotating Shafts Using Constant-Density Sinusoidal Fringe Pattern As Tri-Axial Sensor

A Fiber Bragg Grating Based Torsional Vibration Sensor for Rotating Machinery

A vibration measuring sensor of All- fiber interferometer

A New Type of Dynamic Vibration Fiber Sensor

A dynamic spectral demodulation scheme of the fiber optical Fabry-Perot sensor for low-frequency vibration detection