Abstract:The supercritical CO2 Brayton cycle has promising prospects for application in hypersonic vehicles owing to its performance and compactness. However, the extreme thermal environment in aircrafts and limited cold sources make the transient characteristics of the Brayton cycle unclear. In this study, dynamic models of supercritical CO2 Brayton cycle were established. The heat exchanger model was based on the supercritical moving boundary method proposed in our previous work and the finite volume method, whereas the modeling of the turbomachinery was based on the performance map approach. Proportional-integral-derivative (PID) controller modules were introduced to enable closed-loop control of various parameters to meet different working conditions. The transient characteristics of the heat exchanger and Brayton cycle model were validated using literature data. Dynamic models for both simple and recuperated layouts were developed to study the transient behavior in aerospace scenarios with sudden thermal load increases, cold-source limitations, and combined disturbances. Under the given conditions, results indicate that both sudden increases in thermal load and cold-source limitations cause a decrease in the thermodynamic performance, with a reduction in thermal efficiency of 0.7 and 2.2%, respectively. When these conditions were combined, the performance further deteriorated, with the thermal efficiency decreasing from 14.4 to 9.5%. This condition can result in compressor over speeding and failure of the PID controller. The simulation results for the two layouts show that the recuperated layout has a 34.8% higher power output at the cost of increasing the total weight by 29.7%. The dynamic models proposed in this study provide valuable insights into the behavior of Brayton cycle systems in hypersonic vehicles, aiding system design, evaluation, and control strategy development.

A Preliminary Study on Hypersonic Airbreathing Engine Performance

Conceptual Design and Optimization of Scramjet Engines Using the Exergy Method

Numerical Study of Heat Flux Reduction Mechanism of the Counterflowing Jet in Rarefied Flows

On compression level of hypersonic airflow in high-mach scramjet

Insights into thermodynamic performance of a hypersonic precooled air-breathing engine with a complicated multi-branch closed cycle

Research on the Zooming Method for Determining the Flow, Heat Transfer, and Infrared Radiation of an Air-Breathing Hypersonic Vehicle Powered by a Scramjet

A Rapid Method of Integrated Aeropropulsive Analysis for the Conceptual Design of Airbreathing Hypersonic Aircraft

Aerodynamic Modeling for Hypersonic Flight Vehicles with Account of Scramjet Effects.

Thermodynamic analysis on the performance of hydrocarbon fueled scramjet with inlet active cooling

Design optimization and off-design performance analysis of axisymmetric scramjet intakes for ascent flight

Scramjet performance for ideal combustion processes

Cruise Trajectory Analysis of Scramjet-Powered Hypersonic Vehicle

Multi-objective optimization of a hypersonic airbreathing vehicle

Flight trajectory optimization study of a variable-cycle turbine-based combined cycle engine hypersonic vehicle based on airframe/engine integration

Design space investigations of scramjet engines using reduced-order modelling

Dynamic Simulation and Analysis of Transient Characteristics of a Thermal-to-electrical Conversion System Based on Supercritical CO2 Brayton Cycle in Hypersonic Vehicles

Thermodynamic Analysis of the Second Fluid Brayton Cycle for Scramjet Engine

Quasi-one-dimensional Model of Supersonic a Combustor with Various Fuels

Parametric analysis of thermal cycle of a short take-off and vertical landing engine

A Study of Two Variable Cycle Engine Concepts for High Speed Civil Aircraft

Numerical Investigation on the Effect of Inflow Mach Numbers on the Combustion Characteristics of a Typical Cavity-Based Supersonic Combustor