Abstract:Developing a high-confidence entire aeroengine model that accurately incorporating unstable modes is imperative for advancing active stability control. This paper proposes a real-time model for the active stability control of aeroengines, which integrates the compressor's instability into the classical component level model (CLM). Firstly, the principles of CLM and modeling methods for inlet distortion, compressor instability dynamics, and air injector are introduced. Then, the collaborative relationship between the compressor and the other engine's components are studied to construct a real-time model with coupled instability mechanisms, involving the extension of compressor characteristics and the parameters matching between various instability models and the CLM. Finally, simulation cases under multiple unstable modes are set up to verify the effectiveness of the model, and standard instability detection algorithms are employed to confirm the confidence of the unstable signals generated by the model. The results show that the proposed model effectively captures the dynamic characteristics of stall and surge, as well as the steady-state and dynamic simulation capabilities during full operating range. Besides, it can also simulate the impact of the inlet distortion and the air injection on compressor stability. The pulsating characteristics of pressure signals and the variations of performance parameters of the model during stall and surge are highly consistent with the real test data. Moreover, the model achieves a single-step run time of no more than 7.16ms on the embedded platform, fulfilling real-time requirements. Consequently, the model can serve as a foundation for verifying three critical aspects of active stability control: instability detection, practical actuator, and feedback control algorithms.

Parametric analysis of thermal cycle of a short take-off and vertical landing engine

Simulation of Optimization of Variable Geometry for a Turbofan Engine of a Missile

Dynamics modeling and analysis of thrust-vectored V/STOL aircraft

Design of Thrust Vectoring Vertical/Short Takeoff and Landing Aircraft Stability Augmentation Controller Based on L1 Adaptive Control Law

Modelling, analysis and experimental study of the prop-rotor of vertical/short-take-off and landing aircraft

Research on dynamic modeling and performance analysis of helicopter turboshaft engine's start-up process

A Third-Order Numerical Model and Transient Characterization of a Β-Type Stirling Engine

Control Optimization of the Transient Performance of the Selective Bleed Variable Cycle Engine During Mode Transition

Power Balance Strategies in Steady-State Simulation of the Micro Gas Turbine Engine by Component-Coupled 3D CFD Method

Modeling and Simulation Research on Advanced Short Takeoff and Vertical Landing Aircraft

Multi-nozzle thrust matching control of STOVL engine

Mathematical Model of Two-Stage Turbocharging Gasoline Engine Propeller Propulsion System and Analysis of Its Flying Characteristic

Scavenging Ports’ Optimal Design of a Two-Stroke Small Aeroengine Based on the Benson/Bradham Model

Experimental Investigation on Aerodynamic Instability of Axial Flow Engine

Numerical Study of Fuel Spiking Induced Surge in a Small-scale Aircraft Engine

Modeling and Coupling Characteristics for an Airframe-Propulsion-integrated Hypersonic Vehicle

Simulation analysis and performance optimization of the combustion process of the opposed cam piston engine

Design and Experimental Study of a Turbojet VTOL Aircraft with One-Dimensional Thrust Vectoring Nozzles

Dynamic Modelling Of A Small Scale Turbojet Engine

Unique Operating Conditions Analysis of Turboshaft Engines Based on Nonlinear Integrated Model

A novel aeroengine real-time model for active stability control: compressor instabilities integration