Abstract:The centrifugal compressor is widely used for gas compression in various industrial fields such as aero-engine, gas turbine and turbocharger. However, the stable operating range is usually restricted by the occurrence of flow instability such as stall and surge. The paper experimentally examines the developing process of surge and stall occurring in a centrifugal compressor to advance the understanding on flow mechanism of flow instability. It is found that three types of pressure fluctuation can be observed at low flowrate region. At the critical point, the local stall firstly occurs in some specific diffuser passages and the enlarged local diffuser stall eventually induces the mild surge of compression system indicated by the sinusoidal pressure fluctuation. At lower mass flow rate, the diffuser stall cell begins to circumferentially propagate along the impeller rotating direction at 11% of rotor speed with the existence of mild surge. In comparative analysis of IGV pre-swirl angle on the occurrence of mild surge, the mild surge still occurs at the operating condition when the slope of the characteristic map of test stage is still obviously negative, in which the compression system is supposed to be stable in previous study. And a new suggested criterion for the prediction of mild surge is demonstrated that the occurrence of mild surge depends on the destabi-lization effect of downstream components about diffuser and volute. Combined with the experimental data, the streamwise distribution characteristic of diffuser stall can be used to develop the simplified model of lumped parameters for the analysis on the generation mechanism of the diffuser rotating stall. The quantitative investigation on the relation between the pressure-rise characteristic of subcomponents and the occurrence of mild surge and diffuser rotating stall not only advances the prediction of stability limit but also lays the theoretic foundation for controlling these unsteady behaviors to improve the operating range.

Numerical Study of Fuel Spiking Induced Surge in a Small-scale Aircraft Engine

Surge Process of a High-Speed Axial–Centrifugal Compressor

A Review on Theoretical and Numerical Research of Axial Compressor Surge

Experimental investigation of transient characteristics of mild surge and diffuser rotating stall in a centrifugal compressor with vaned diffuser

Stall Margin Improvement in an Axial Compressor by Continuous and Pulsed Tip Injection

Investigation of the Flutter Stability of a Transonic Fan with Inlet Distortion

Numerical Simulation Method of Surge Experiments on Gas Turbine Engines

Unsteady Flow and Aeroelasticity Behavior of Aeroengine Core Compressors During Rotating Stall and Surge

Evaluation of Surge Prediction Capabilities of Body-Force Model on a High-Speed Multi-Stage Axial-Radial Compressor

INVESTIGATION ON THE UNSTEADY SURGE FLOW BEHAVIOR OF AN AXIAL-CENTRIFUGAL COMPRESSOR

A Method of Stall and Surge Prediction in Axial Compressors Based on Three-Dimensional Body-Force Model

Simulation of Optimization of Variable Geometry for a Turbofan Engine of a Missile

Numerical investigation of deep surge in a centrifugal compressor with vaned diffuser and large plenum

Flow Physics During Surge of an Axial-Centrifugal Compressor

Surge-elimination Strategy for Aero-engine Transient Control

Numerical Investigation of Flow Evolution in Centrifugal Compressors During Surge

A Rapid Predicting Model for Aerodynamic Instability in Aero-Engine

A Characteristic-Based 1D Axial Compressor Model for Stall and Surge Simulations

Numerical simulation of unsteady single-stage transonic axial compressor flow

Parametric analysis of thermal cycle of a short take-off and vertical landing engine

Numerical Simulation on Unsteady Flow Mechanism of a 1.5-Stage Axial Transonic Compressor