Abstract:The current rapid development of weak electrical installations has made the monitoring of weak signals increasingly important. For highly sophisticated instruments, the slightest signal deviation will cause terrible and irreparable damage. At present, commercially available multimeters generally have low accuracy, which does not meet the error range required for weak electrical signal monitoring, because it cannot be monitored in real-time, and requires manual handheld data collection. To address the above demands, this study designs and builds a voltage and current signal collector based on the STM32F103 microcontroller. In this case, the DC voltage is designed in the range of −5 V to 5 V, and for the current is from 4 to 20 mA, and the AC voltage from 0 to 5 V can be measured. The measurement results will be displayed on the LCD screen. The collector uses RS485 as the physical transmission interface and the communication protocol uses the Modbus-RTU protocol, which can work properly in the range of 10–24 V DC supply. The analysis of the corresponding requirements is followed by the circuit design to complete the transmission and display of the collected data. The DC voltage measurement part contains the process of boosting and dividing the circuit and then reading it, the current measurement is completed by an isotropic proportional amplifier circuit, and the AC voltage RMS measurement uses the AD637 true RMS conversion chip to realize the circuit, the design contains the software part, the hardware part, and the communication part design. The final device has been tested to meet the national standard of maximum permissible error range within ±0.1 and is suitable for the complex environment envisaged.

Development of a Kind of Weak Current Tester Based on I-F Conversion

Interferometric Fiber-Optic Current Sensor

Weak Current Detection Based On The Faims System

Weak-current Measurement in a Micro-electrochemistry System

Research and Development of a Quantitative Human Current Perception Threshold Testing System

Weak Current Signal Detection Device Based on Embedded System

Development of Two-in-one Test Device for Oscillating Wave and 0.1hz Cosine Square Wave

Design of Measurement Circuit for Weak DC Signal

A Non-Contact Broad Bandwidth Current Sensor

Design and Analysis of Power Semiconductor Test Circuits

Design and Simulation of a Magnetic Balance Weak Current Sensor Based on TMR

A Sensor for the Ultraweak DC Current Covered by Strong AC Currents

Packaged Current-Sensing Device with Self-Biased Magnetoelectric Laminate for Low-Frequency Weak-Current Detection

A Low-Noise Int-Diff Small Direct Currents Measurement System with Two-Stage Amplifier and Digital Differentiator

Optical Current Transducer For Electric Power System

Development on the Zero-Flex Type Current Sensor

Development of a leakage current monitoring system of iced insulators base on fiber optic transmission

Design of Current Transformer for <italic>in Situ</italic> Current Measurement of Discrete SiC Power Devices

Development of the Instrument for Testing Active Device's Voltage-Current Characteristic

Measurement System Using Hybrid Optical Current Transducer for Small Pulse Current Signal

Performance Analysis and Experimental Investigation of Optical Current Transducers