Microstructure of MmNi3.5(CoAlMn)1.5/Mg Multi-layers for Hydrogen Storage

Liu-zhang OUYANG,Hui WANG,Jin ZOU,Min ZHU
DOI: https://doi.org/10.3321/j.issn:1671-4431.2006.z1.055
2006-01-01
Wuhan Ligong Daxue Xuebao/Journal of Wuhan University of Technology
Abstract:The change of microstructures and hydrogen storage properties of MmNi3.5(CoAlMn)1.5/Mg (MmM5 denoting MmNi3.5(CoAlMn)1.5 here and thereby) multi-layer thin films were studied by using X-ray diffraction(XRD). XRD results shows that Mg/MmM5 multi-layer thin films could absorb and desorb hydrogen at 473 K and 523 K respectively. The change of microstructures of Mg/MmMs multi-layer thin films as-prepared and as rapid thermal annealing (RTA) at 400 °C for 3 minutes in a furnace was also studied by using cross section transmission electron microscopy (XTEM) in order to monitor the real microstructure when hydrogenation/dehydrogenation takes place. These Mg columnar crystallites have their [001] directions roughly parallel to the growth direction and the average lateral size of these columnar crystallites is about 100 nm. After annealing, the nanocrystalline region extends to 250 nm thick and the columnar crystallites becomes to about 200 nm. On the other hand, the MmM5 layer in the as-prepared thin films contains two regions as well: an amorphous region of about 4 nm thick at the bottom of the layer with a nanocrystalline region on the top. After annealing, the entire MmM5 layer turns into nanocrystalline.
What problem does this paper attempt to address?