Abstract:Improving the mixing homogeneity of heterogeneous powder in real time plays an essential role in ensuring the forming quality of functionally graded materials (FGM) produced by laser-directed energy deposition (L-DED). In order to achieve a high performance of material composition and proportion control as forming FGM parts, this paper investigates the mixing mechanism of several typical powders including 316L and NiCrCoAlY used for the L-DED process driven by compressed gas. An innovative pneumatic powder mixer is designed and optimized by the CFD-DEM simulation method to analyze the mixing characteristics of heterogeneous particles. To improve the real-time mixing homogeneity of different mixing ratios in the conveying process, mixing experiments based on differences in powder properties were conducted by the additive-subtractive composite machining center, and a coefficient of variation method was proposed to describe the mixing homogeneity of non-uniform powders. The results of micro-morphology and EDS indicate that the mixing quality of the two-phase flow is significantly enhanced with the four 45° compression inlets and 2 m/s inlet velocity structure. The results show that the numerical analysis method proposed in this paper can effectively describe the mixing law of heterogeneous particles, and the compressed air intake velocity should not exceed the initial two-phase flow velocity. The horizontal and vertical components generated by the compressed air intake at 45° are more conducive to the formation of favorable perturbations to the two-phase flow, and the number of four and eight compressed air intakes that act uniformly on the flow field is more appropriate. After a certain period of time, the two-phase flow with low error of mixed powder quality can be produced continuously. The mixed powder quality is obviously improved after the disturbance of compressed air intake. The mixing uniformity of powder with low spherical particle proportion can be effectively improved by increasing the preset mixing proportion of non-spherical particles.

Design of dosing powder feeding system for plasma deposition manufacturing

Simulation and Optimal Control of Fluidized Bed Based Powder Feeder for Laser Remanufacturing

Research on the Control System of Powder Feeder for Laser Remanufacturing Based on MCU

Study on the Powder Feeding Technique during Laser Micro Cladding Deposition Manufacturing of TC4 Powder

Investigation of the Vibrating Feeding System for Sphericity Separation of Coated Fuel Particles Using DEM

Structural Optimized Design of a Powder Mixer for Multi-Material Directed Energy Deposition Based on CFD-DPM

A Control System Design for Nanoparticle Manufacturing by Using Impinging-Jet Micromixers

Application of Near-Infrared Spectroscopy Combined with Design of Experiments for Process Development of the Pulsed Spray Fluid Bed Granulation Process

Design of an Electronically Controlled Fertilization System for an Air-Assisted Side-Deep Fertilization Machine

Design and development on automated control system of coated fuel particle fabrication process

Experimental Study on the Mass Flow Rate Characteristics of a Fluidized Bed Powder Fuel Feeding System

Design of Typical Device for Powder Surface Modification of Micron and Nano-sized Powder by Mechano-mixed Method

Powder Mixed EDM Stirrer Designing and Simulation

Powder Disperser for the Continuous Aerosolizing of Dry Powdered Nanoparticles

Evaluation of powder mixing homogeneity for laser-directed energy deposition (L-DED) of functionally graded materials

Vibratory Powder Feeding for Powder Bed AdditiveManufacturing using Water and Gas Atomized MetalPowders

Development of a height control system using a dynamic powder splitter for directed energy deposition (DED) additive manufacturing

Study on Controllable Vibration Powder Spreading System in Electron Beam Selective Melting

Design and Analysis of Powder Vertical Spiral Feeding Based on EDEM

Investigation on the deposition rate and the dilution ratio of plasma surface welding

Design of a Plasma Emission Monitoring System Used in a Reactive Sputtering Coating