Abstract:Improving the mixing homogeneity of heterogeneous powder in real time plays an essential role in ensuring the forming quality of functionally graded materials (FGM) produced by laser-directed energy deposition (L-DED). In order to achieve a high performance of material composition and proportion control as forming FGM parts, this paper investigates the mixing mechanism of several typical powders including 316L and NiCrCoAlY used for the L-DED process driven by compressed gas. An innovative pneumatic powder mixer is designed and optimized by the CFD-DEM simulation method to analyze the mixing characteristics of heterogeneous particles. To improve the real-time mixing homogeneity of different mixing ratios in the conveying process, mixing experiments based on differences in powder properties were conducted by the additive-subtractive composite machining center, and a coefficient of variation method was proposed to describe the mixing homogeneity of non-uniform powders. The results of micro-morphology and EDS indicate that the mixing quality of the two-phase flow is significantly enhanced with the four 45° compression inlets and 2 m/s inlet velocity structure. The results show that the numerical analysis method proposed in this paper can effectively describe the mixing law of heterogeneous particles, and the compressed air intake velocity should not exceed the initial two-phase flow velocity. The horizontal and vertical components generated by the compressed air intake at 45° are more conducive to the formation of favorable perturbations to the two-phase flow, and the number of four and eight compressed air intakes that act uniformly on the flow field is more appropriate. After a certain period of time, the two-phase flow with low error of mixed powder quality can be produced continuously. The mixed powder quality is obviously improved after the disturbance of compressed air intake. The mixing uniformity of powder with low spherical particle proportion can be effectively improved by increasing the preset mixing proportion of non-spherical particles.

Simulation and Optimal Control of Fluidized Bed Based Powder Feeder for Laser Remanufacturing

Research on the Control System of Powder Feeder for Laser Remanufacturing Based on MCU

Simulation and Experimental Research Based on Carrier Gas Flow Rate on the Influence of Four-Channel Coaxial Nozzle Flow Field

Powder flow simulation of a ring-type coaxial nozzle and cladding experiment in laser metal deposition

Study on the Powder Feeding Technique during Laser Micro Cladding Deposition Manufacturing of TC4 Powder

Development of a Controlled Continuous Low-Dose Feeding Process

Numerical simulation and experimental investigation on powder transport of a new-type annular coaxial nozzle

Vibratory Powder Feeding for Powder Bed AdditiveManufacturing using Water and Gas Atomized MetalPowders

Design and Numerical Analysis of an Inside-Beam Powder Feeding Nozzle for Wide-Band Laser Cladding

Multi-objective Numerical Simulation of Geometrical Characteristics of Laser Cladding of Cobalt-Based Alloy Based on Response Surface Methodology

Experimental Study on the Mass Flow Rate Characteristics of a Fluidized Bed Powder Fuel Feeding System

An empirical model for feedforward control of laser powder bed fusion

Simulation and Experimental Investigation of Fe-based Alloy Powder Production by Gas Atomization

Numerical Study on Powder Stream Characteristics of Coaxial Laser Metal Deposition Nozzle

Evaluation of powder mixing homogeneity for laser-directed energy deposition (L-DED) of functionally graded materials

Part geometry and conduction-based laser power control for powder bed fusion additive manufacturing

Adaptive powder nozzle setup for enhanced efficiency in laser metal deposition

Layer-to-Layer Melt Pool Control in Laser Powder Bed Fusion

Full cycle numerical simulation during the pulsed laser cladding process considering the interaction between laser and powder

Coupled Computational Fluid Dynamics-Discrete Element Method Model for Investigation of Powder Effects in Nonconventional Laser Powder Bed Fusion Process

Numerical Investigation of In-Flight Behavior of Fe-Based Amorphous Alloy Particles in AC-HVAF Thermal Spray Process