Abstract:The SO2/NOX pollution in the flue gas of non-ferrous smelting is increasingly serious. At the same time, the accumulation of red mud (RM) in the aluminum industry and phosphorus sludge (PS) in the yellow phosphorus industry has caused serious harm to the environment. To remove SO2 and NOX from the non-ferrous smelting flue gas and realize the resource utilization of the above two solid wastes, an ultrasonic field was used in this study to strengthen the PS excited O3 process and RM wet desulfurization and denitrification process. In the process of O3 excitation, the response surface method (RSM) is used to obtain the optimal O3 excitation concentration, and the optimal reaction conditions are designed based on the response surface optimization model: T is 53.226 °C, power density is 0.4 W/cm2, PS concentration is 51.433 g/L, O3 formation concentration up to 250 ppm or more, which provides a theoretical basis for subsequent desulfurization and denitrification steps. It is proved that this study can replace the expensive traditional O3 generator and provide a basis for NOX removal in the following process. In addition, the optimum experimental conditions of ultrasonic enhanced RM desulfurization and denitrification process were also explored. Under ultrasonic frequency of 28 kHz, ultrasonic power density of 0.4 W/cm2, T of 50 °C, RM concentration of 15 g/L, and stirring intensity of 1000 rpm, the desulfurization efficiency of the reaction system can be maintained above 95 % within 250 min, and the denitrification efficiency can be maintained above 90 % within 250 min. The effect of desulfurization and denitrification in this study is much better than that of traditional methods. Finally, the reaction mechanism of ultrasonic enhanced O3 excitation and RM wet desulfurization and nitrogen removal was discussed by combining adsorption thermodynamics, isotherm, and kinetics. The results showed that the OH· free radicals generated by ultrasonic cavitation and the physical effects brought by emulsification had significant promoting effects.

Research on Technology of Purifying Yellow Phosphorus Tail Gas to Produce Formic Acid and Dimethyl Carbonate

Present Situation and Prospect of Recovery and Utilization of Yellow Phosphorus Tail Gas

A Novel System for Continuous Production of Formic Acid Based on Recycling of Yellow Phosphorous Tail Gas

Experimental Research on a Process for the Recycling of Yellow Phosphorous Tail Gas to Produce Formic Acid

Parametric Optimization of Novel Process for Recovering Yellow Phosphorous Tail Gas to Produce Formic Acid

Reconfiguration of Acid Gas Removal Process Matching the Integration of Coal Chemical Industry with Green Hydrogen

Reducing Aerosol and Ammonia Emission in Post-Combustion CO2 Capture: Additives As Key Solutions

Selective Conversion of Organic Pollutant P-Chlorophenol to Formic Acid Using Zeolite Fenton Catalyst

Novel Method for High-Performance Simultaneous Removal of NOx and SO2 by Coupling Yellow Phosphorus Emulsion with Red Mud

Ultrasonic-enhanced Phosphorus Sludge Excited O3 Coupled Red Mud Simultaneous Desulfurization and Denitrification

The Heat Recovery and Utilization in the Production of Furnace-process Phosphoric Acid

Recent Advances in Elimination of SO2 and NOx from Flue Gas Employing Phosphorus Sludge and Phosphate Rock

Recent Advances in Elimination of SO<sub>2</sub> and NO<sub> <i>x</i> </sub> from Flue Gas Employing Phosphorus Sludge and Phosphate Rock

Effect of rare earth addition on Cu-Fe/AC adsorbents for phosphine adsorption from yellow phosphorous tail gas

Simultaneous Removal of Sulfur Dioxide and Nitrogen Oxide from Flue Gas by Phosphorus Sludge: the Performance and Absorption Mechanism

[Recovery of CO from an Ammonia Plant Tail Gas with Pressure Swing Adsorption Process].

The Recycling of Acid Wastewater with High Concentrations of Organic Matter: Recovery of H2SO4 and Preparation of Activated Carbon

Analysis on Purification Degree in Treatment of Phenol-cyanogen Wastewater and Flue Gas in the Coking Process

Waste carbon conversion and utilization in chemical wastewater treatment process: Experimental approaches from lab-to pilot-scale

Development Of Multi-Pollutants Control Technology For Flue Gas From Power Plants In China

Summary of research progress on industrial flue gas desulfurization technology