Abstract:Magnetocardiography (MCG) is an effective modality for clinical application and health monitoring due to non-contact measurement and mapping of heart activity at high spatial resolution. A superconducting quantum interference device (SQUID) magnetometer is usually used for measuring MCG signals. However, a SQUID magnetometer has high running cost due to the liquid helium. Moreover, measuring MCG signals inside a magnetically shielded room (MSR) can be costly. Therefore, we developed a 64-channel magneto-impedance (MI) sensor system that does not require an MSR. However, the MCG measurement has very high noise level without an MSR. In this paper, we discuss the signal processing techniques of various noise reduction methods to decrease very loud noises. In particular, we investigated three spatial filter conditions that decrease correlated noises among the 64-channel signals to achieve a high peak value of MCG signals. By using a spatial filter that uses the average of the circumference channels and gradient, the distortion of MCG signals can be reduced. The average reduction in amplitude of the R wave as a result of using a spatial filter was 4.5 pT. Furthermore, the signal to noise ratio (SNR) of the P wave was 29.1 dB, while that of the R wave was 42.3 dB, and clear MCG signals were obtained when using the spatial filter that uses the average of the circumference channels and the gradient. Finally, we successfully measured the MCG signals without an MSR.

An Economical Magnetocardiogram System Based on High- T C SQUIDs

Multi-Channel Magnetocardiogardiography System Based on Low-Tc SQUIDs in an Unshielded Environment

Simulation of MCG Signal in 2D Cardiac Tissue Sheet with Ischemic Condition

A High-Tc Dc-Squid-based Single-Channel MCG and Its Performance

Low- T c direct current superconducting quantum interference device magnetometer-based 36-channel magnetocardiography system in a magnetically shielded room

Single-channel Dc High-Temperature Superconducting Quantum Interference Device Magnetocardiograph

Simulation Study of A Magnetocardiogram Based on A Virtual Heart Model: Effect of A Cardiac Equivalent Source and A Volume Conductor

SQUID-Based MCG Measurement Using a Full-Tensor Compensation Technique in an Urban Hospital Environment

Analysis of MCG measured by high-Tc SQUID with spatial filter method

Low Field NMR System Based on High T_c DC-SQUID

A Simplified Htc Rf Squid to Analyze the Human Cardiac Magnetic Field

A Movable Unshielded Magnetocardiography System.

Study of Spatial Filter for Magnetocardiography Measurements without a Magnetically Shielded Room

Measurements of the Magnetocardiography in Unshielded Environment Using High-Tc Rf SQUID Gradiometer

Quantitative Evaluation of Signal Integrity for Magnetocardiography

A New Magneto-Cardiogram Study Using A Vector Model with A Virtual Heart and the Boundary Element Method

Performance and Clinical Application of the 9 Channel Magnetocardiography Measurement System

Recording the Distribution of Cardiac Magnetic Fields in Unshielded Earth's Field

Low-drift and compact readout electronics for practical SQUID magnetocardiography working in unshielded environment

A new wearable multichannel magnetocardiogram system with a SERF atomic magnetometer array